Install Washing Machine; Connect The Power - X-Vision TG72-BS Manual

Operate Washing Machine

Install Washing Machine

Connect the power

As the maximum current through the unit is 10A when
·
you are using its heating function, please make sure
the power supply system (current, power voltage and
wire) at your home can meet the normal loading
requirements of the electrical appliances.
Please connect the power to a socket which is correctly
·
installed and properly earthed.
Make sure the power voltage at your plate is same
·
to that in the machine's rated voltage.
Power plug must match the socket.
·
Do not use multi-purpose plug or socket as extension cord.
·
Do not connect and pull out plug with wet hands.
·
When pulling out the plug, hold the plug tightlly and then pull it out. Do
·
not pull power cord forcibly.
If power cord is damaged or has any sign of being broken, special power
·
cord must be selected or purchased from its manufacturer or service
center for replacement.
WARNING
1.This machine must be earthed properly. If there is any short circuit,
earthing can reduce the danger of electrical shock.
2.Washing machine shall be operated in a circuit separate from other
electrical appliances. Otherwise, power protector may be tripped or
fuse may be burned out.
Operate Washing Machine
NOTE
Ensure your machine is installed properly before use.
Before washing clothes for the first time, you must run a complete cycle
without clothes. To do this:
1.Connect power source and water.
2.Put a little detergent(about 10g) into the drawer and close it.
3.Press the On/Off button.
4.Turn the knob to the "Cotton" .
5.Press the Start/Pause button.
This will remove any water from the manufacturer's test run remaining
in the machine.
7
7