Page 1
2500 Watt Oil Filled Radiator with Thermostatic Control This manual is to be used with the following SupaWarm radiator: FR11D RTANT: Read these instructions before use. Please retain for future reference. INSTRU C TION MANUAL INCLUDES 24 HOUR TIMER This product is only suitable for well...
Page 2
(A) Castor Wheels (B) Power Cable Storage ) 24 Hour Timer Dial (D) Variable Thermostat Control 2 On/Off Heat Power Buttons Carry Handle (G) Oil Filled Fins...
Page 3
RATING AC 220-240V ~ 50/60Hz, 2500W. • Ensure that the voltage indicated on the identification plate • corresponds with the mains voltage. Please read these instructions fully before use. WARNING! This appliance must be earthed. DO NOT TURN HEATER UPSIDE-DOWN DURING OPERATION. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH...
Page 4
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. When using an electrical appliance, basic safety precautions should always be observed, as explained in this manual. WARNING: To reduce the risk of fire, electrical shock, or injury to person or property: This appliance is not intended for use by persons (including •...
Page 5
If the supply cord is damaged, it must be replaced by the • manufacturer or its service agent or a similarly qualified person to avoid a hazard. Avoid the use of an extension cord as this may overheat • and cause a risk of fire. Use the heater in a well-ventilated area.
Page 6
Repair requiring opening of the oil container is only to be • made by a service agent who must be contacted if there is an oil leakage. Regulations concerning the disposal of oil when scrapping • the appliance have to be followed. The heater should not be used in a room, of which the floor •...
Page 7
Always remove the plug from the socket-outlet and allow • the radiator to cool down before cleaning the heater. Wipe radiator with a soft damp (not wet) cloth. • WARNING: Do not immerse the heater in water. Do not use any cleaning chemicals such as detergents and abrasives.
Page 8
The heater is packaged with the feet unattached. You must attach them before operating the heater. Ensure the power cord is not plugged in before attempting to assemble the heater. The only assembly required for the oil heaters are attaching the wheels onto the main unit.
Page 9
PLEASE NOTE: Do not over tighten, which may cause the damage of radiator flange. 5. Screw off spherical nut from the castor, align the shaft to the hole of the castor mounting plate, insert in, and screw on the spherical nut. 6.
Page 10
1. Before using the heater, make sure that it is on a flat and stable surface. Damage may occur if it is placed on an incline or decline. Place the heater on the floor at least 90cm away from the wall and any other flammable objects such as furniture, curtains or plants.
Page 11
1. Select the amount of time that you require by turning the timer clockwise (do not turn anticlockwise). 2. Turn the timer on by switching to 3. When the switch is set to on the timer, choose the time frame you require. There are 96 small pins on the timer, each pin represents a 15 minute interval.
Page 12
Ipswich, Suffolk, IP3 9OR Declare that the product: Product code: 329861 SOFR11D Product description: SupaWarm 2500w 11 Fin Oil Filled Radiator Is in conformity with the relevant statutory instruments and their amendments: EMC Direc�ve 2014/30/EU and The Electromagne�c Compa�bility Regula�ons 2016 Low Voltage Direc�ve 2014/35/EU and The Electrical Equipment (Safety) Regula�ons 2016...
Page 13
The heater operates in silence as there are no moving parts. The heater has a built-in sensor which will turn the heater off if it over- heats. All 11 fins will heat up when the unit has been switched on. Use the dial to adjust the temperature setting to your desired comfort level.
Page 16
For a complete range of fires, radiators and heaters...
Need help?
Do you have a question about the SOFR11D and is the answer not in the manual?
Questions and answers