Page 2
Feet Handle Thermostat Knob Air Outlet Grid Power Switch Air Inlet Grid Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit. These are to be attached to the base of the heater using the 4 self-tapping screws provided, taking care to ensure that they are located correctly in the bottom ends of the heater side mouldings.
Page 3
RATING AC 220-240V ~ 50Hz, 1800-2000W. Ensure that the voltage indicated on the identification plate corresponds with the mains voltage. Please read these instructions fully before use. WARNING! This appliance must be earthed. THE HEATER MUST BE POSITIONED UPRIGHT. IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002...
Page 4
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. WARNING! In order to avoid overheating, please DO NOT COVER heater during use. DO NOT use the heater unless the feet are correctly attached. Ensure the power supply to the socket into which the heater is plugged is in accordance with the rating label on the heater and that the socket is earthed.
Page 5
In order to avoid overheating, do not cover the heater. Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. Children of less than 3 years should be kept away from the heater unless continuously supervised.
Page 6
It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time, the heaters may emit some smell and fumes. This will disappear when the heater has been on a short while.
Page 7
Ipswich Suffolk IP3 9OR Declare that the product: Product code: 493000 SCH2000T Product descrip�on: SupaWarm 2000w Turbo convector heater Is in conformity with the relevant statutory instruments and their amendments: Electromagne�c Compa�bility Regula�ons 2016 and EMC Direc�ve 2014/30/EU Electrical Equipment (Safety) Regula�ons 2016 and Low Voltage Direc�ve 2014/35/EU Commission Regula�on (EU) 2015/1188 implemen�ng Direc�ve 2009/125/EC of the European Parliament and of the Council...
Page 9
Always un-plug the heater from the wall socket and allow it to cool down before cleaning. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth. Do not use any detergents or abrasives and do not allow any water to enter the heater.
Need help?
Do you have a question about the SCH2000T and is the answer not in the manual?
Questions and answers