Basic Instructions; Installation - BorMann Elite BTW3500 Manual

EN

Basic instructions

Basic Functions
1. The instant water heater is equipped with leakage protection. When a leakage occurs, the appliance automatically cuts off
the heating output in order to ensure safety.
2. Overheating protection: when the outlet water temperature is more than 50
interrupt the heating procedure in order to prevent burns or injuries.
3. The heating protection does not function during icing conditions: when the temperature drops excessively (0-2 degrees
Celsius), the appliance will not be heating.
4. Dry burning-resistant protection.
Using the appliance
1. After confirming that the water heater is installed properly, let the water in and close the water inlet valve when water comes
out from the water outlet.
2. Close the switch with which you have turned on the water heater. At this time a beeping sound comes from the buzzer.
3. Press ON/OFF to turn on the water heater switch. The display screen lights up. At this time, the outlet water temperature can
be set by pressing the UP/DOWN button. Every time you press the UP button, the temperature rises by one degree. Everytime
you press the DOWN button, the temperature falls by one degree - to a minimum.
4. After setting the outlet temperature, open the inlet valve and the water heater enters into the heating state. The temperature
displayed on the display screen rises gradually until it reaches the set point and maintains. When the water flow is too large, it
must adjusted in order to achieve the set outlet temperature. When the water flow is on the contrary inadequate, the appliance
will stop the heating procedure as the water flow will be required to be adjusted accordingly. The appliance has the function of
overheated protection. When the outlet water temperature exceeds 50
procedure. If the water temperature drops to a certain temperature, the appliance will automatically return to the previous
heating procedure.
5. By closing the water inlet valve, the water heater will stop heating. The appliance is also characterized by a memory function.
When the water inlet valve is opened again, the appliance will automatically enter in the working state as previously without
any readjustment. The appliance is very convenient to use, in general.

Installation

1. Tools required: percussion drill, hammer, cross screwdriver, wrench, pliers.
2.Materials: wires, matching leakage switch or suitable and safety wiring tools, insulation packing materials, water pipe fittings,
water pipe sealing materials.
3
ELCB
HEAT
ELCB: Light is ON = Normal/Safe Operation
ELCB: Light is flashing = Electric leakage detected
DOWN (TEMP.)
Wall mounted bathroom-kitchen-wash basin
electric, single phase, instant water heater
6 kW
Fig. 1 Instant water heater
HEAT: Light is ON = The water is being heated
HEAT: Light is OFF = No heating is taking place
Celsius, the instant water heater will stop the heating
o
WWW.NIKOLAOUTOOLS.GR
TEMPERATURE DISPLAY
UP (TEMP.)
Yellow/green Blue Brown
OFF/ON
WATER INLET
WATER OUTLET
Celsius, the appliance will automatically
o