Advertisement
Available languages
Available languages
OPTION SELECTIONS
OPTIONS
DISH LOAD TYPES
For best drying results.
To sanitize your dishes and
glassware in accordance
with NSF/ANSI Standard
184 for Residential
Dishwashers.
Loads containing tough,
baked-on food
To run your dishwasher at
a later time or during off-
peak hours.
Control Lock
To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROLS AND
CYCLE STATUS
CONTROL
PURPOSE
To start or resume a
wash cycle
To cancel wash cycle
To follow the progress
and status of your
dishwasher cycle
DESCRIPTIONS
This option with the use of rinse aid will provide the best
drying performance.
Raises the water temperature in the final rinse to
approximately 155ºF (68ºC). This high temperature rinse
sanitizes your dishes and glassware in accordance with
NSF/ANSI Standard 184 for Residential Dishwashers.
Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize option adds heat and time to a cycle.
Increases the target water temperature during the wash
portions of the cycle.
Adds heat, wash time and water to the cycle.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press 6 HOUR DELAY.
Press START/RESUME. Close the drawer firmly.
To turn on Lock, press and hold SENSOR DRY for at
least 3 seconds.
To turn off Lock, press and hold SENSOR DRY for at
least 3 seconds.
When Control Lock is lit, all buttons are disabled. If you
press any pad while your dishwasher is locked, the light
flashes 3 times. The dishwasher drawer can be opened
while the controls are locked.
COMMENTS
If the drawer is opened during a cycle, a delay, or the power is interrupted, the Start/
Resume indicator flashes. To restart the drawer, open the drawer, press START/RESUME
and close the drawer firmly within 4 seconds.
Close the drawer firmly. The dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. If the Cancel button is pressed a second time, the drawer
will turn off.
Clean indicator glows when a cycle is finished.
Rinse Aid Low indicator light glows when the rinse aid dispenser needs to be refilled.
USE WITH:
All cycles, except Rinse
Only. Automatic with all
wash cycles unless you
turn it off.
Normal cycle and Sensor
Clean. Heavy Wash cycle
automatically uses
Sanitize. Only these
sanitization cycles have
been designed to meet
the NSF/ANSI
requirements.
Sensor Clean, Heavy
Wash or Normal
All cycles, except Rinse
Only
Anytime
5
Advertisement
