Cleaning; Cleaning Under The Mower; Waste Disposal - Toro 74925 Operator's Manual

6 2
1
g015594
Figure 100
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Place the spacer and spring onto the grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure one J end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 100.
3. Install the bolt and nut. Place one J hook end of the
spring around the grass deflector (Figure 100).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
4
7
3
5
5. Spring installed
6. Grass Deflector
7. J hook end of spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Raise the mower to the transport position.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
61