Chassis Tightening Torques - Yamaha YZ250FM 2021 Owner's Service Manual

Item
Stator coil assembly lead holder bolt
Coolant temperature sensor
Gear position switch bolt
Rectifier/regulator bolt
ECU bolt
Ignition coil bolt
Starter motor bolt
Nut (holder)
Throttle position sensor screw
Intake air pressure sensor screw
TIP
Cylinder head bolt
Tighten all the cylinder head tightening bolts evenly in the tightening order to 30 N·m (3.0 kgf·m, 22
lb·ft). Remove the one bolt according to the tightening order. When doing so, do not remove the other
bolts. Retighten the bolt to 15 N·m (1.5 kgf·m, 11 lb·ft), and then tighten it further to reach the speci-
fied angle (60). Remove the remaining bolts one by one in the same manner and retighten them.
Finally, tighten all the bolts to reach the specified angle (60). Total tightening angle: 60 + 60 = 120
(The first and second time, be sure to apply molybdenum disulfide oil to the bolt threads and seats
as well as to both sides of the lock washers.)
EAM30204

CHASSIS TIGHTENING TORQUES

TIP
- marked portion shall be checked for torque tightening after break-in or before each race.
Thread
Q'ty
size
M5 1
M10 1
M5 2
M6 2
M5 2
M6 2
M6 2
M6 1
M5 1
M6 1
FWD
x3 x1
3 3
1 1
2-12
TIGHTENING TORQUES
Tightening torques
8 N·m (0.8 kgf·m, 5.9 lb·ft)
14 N·m (1.4 kgf·m, 10 lb·ft)
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
7 N·m (0.7 kgf·m, 5.2 lb·ft)
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
7 N·m (0.7 kgf·m, 5.2 lb·ft)
10 N·m (1.0 kgf·m, 7.4 lb·ft)
8 N·m (0.8 kgf·m, 5.9 lb·ft)
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
3.5 N·m (0.35 kgf·m, 2.6 lb·ft)
2 2
4 4
Remarks
LT
LT