Multiple Flash Shooting Using Cords - Nikon SB-600 Instruction Manual

Multiple flash shooting using cords

The SB-600 can be used with Speedlights compatible with the TTL auto flash
mode to perform multiple flash shooting using cords.
• When using a Speedlight that has a standby function as a remote flash unit, make sure
that the standby function is set to off, or select a standby duration that is long enough
by using the Custom Settings.
• Use of the SB-50DX and SB-23 as remote flash units is not recommended, because the
standby function cannot be canceled.
• Speedlights SB-11, SB-14, SB-140, and SB-21B cannot be used with the F-401/N4004
or F-401s/N4004s as either master or remote flash units.
• There is no limitation in usable cameras.
• With cameras compatible with CLS and digital SLRs not compatible with CLS, Manual
flash operation only is possible.
●●●
Be sure to cancel the master flash unit's Monitor
Preflashes setting
When shooting with multiple flash using cords in the TTL mode, cancel the
master flash unit's Monitor Preflashes setting by following one of the methods
described below. Monitor Preflashes can cause incorrect exposures.
SB-800
SB-80DX, SB-50DX
SB-800, SB-600, SB-80DX,
SB-50DX, SB-28, SB-28DX,
SB-27, SB-26, SB-25
Built-in Speedlight
(F80-Series/N80-Series, F75-Series/
N75-Series, F70-Series/N70)
• Cancel the master flash unit's Monitor Preflashes setting when performing
SU-4 type wireless multiple flash operation using the SB-600 as a master
flash unit. For details, refer to instruction manuals provided with the Wireless
Slave Flash Controller SU-4 and Speedlights (such as SB-800) featuring SU-4
type multiple flash operation.
66
All manuals and user guides at all-guides.com
• Set the SU-4 type wireless multiple
• Set the wireless flash mode.
• Set the flash mode to Standard TTL
• Tilt the flash head up.
• Use a non-CPU lens.
• Set the camera's exposure mode to
flash mode
flash.
Manual (M)