Troubleshooting - AEG SCK618F3FS User Manual

Hide thumbs Also See for SCK618F3FS:
Table of Contents

Advertisement

Available languages

Available languages

7. Set the temperature regulator to obtain
the maximum coldness and run the
appliance for at least 3 hours using this
setting.
Only after this time put the food back into the
freezer compartment.
7.5 Period of non-operation
When the appliance is not in use for long
period, take the following precautions:

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates continual‐
ly.
The compressor does not start im‐
mediately after pressing the "Frost‐
matic", or after changing the temper‐
ature.
Door is misaligned or interferes with
ventilation grill.
36
ENGLISH
1. Disconnect the appliance from electricity
2. Remove all food.
3. Defrost the appliance.
4. Clean the appliance and all accessories.
5. Leave the doors open to prevent
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The door is left open.
Temperature is set incorrectly.
Many food products were put in at
the same time.
The room temperature is too high.
Food products placed in the appli‐
ance were too warm.
The door is not closed correctly.
The Frostmatic function is switched
on.
The compressor starts after a period
of time.
The appliance is not levelled.
supply.
unpleasant smells.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli‐
ance to the mains socket. Contact a
qualified electrician.
Check if the appliance stands sta‐
ble.
Close the door.
Refer to "Control panel" chapter.
Wait a few hours and then check the
temperature again.
Refer to "Installation" chapter.
Allow food products to cool to room
temperature before storing.
Refer to "Closing the door" section.
Refer to "Frostmatic function" sec‐
tion.
This is normal, no error has occur‐
red.
Refer to installation instructions.

Advertisement

Table of Contents
loading

Table of Contents