Cafe CDT800 Series Owner's Manual page 9

Hide thumbs Also See for CDT800 Series:
Table of Contents

Advertisement

Available languages

Available languages

Getting Started
Select Options
5
The light by the selected pad will be lit to indicate which Option has been selected.
Normal
This option is for normally soiled dishes, optimizes wash performance while conserving energy.
Temp
Hi-Temp
This option increases the temperature to help clean heavily soiled dishes and will increase the
Wash
cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
option will also improve dry performance on the Normal cycle.
Wash
This option raises the water temperature in the final rinse to sanitize your dishware but may
Presoak +
increase cycle time by 60 minutes. The cycle length will vary depending on the temperature of
Sani
your inlet water.
NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
Sanitized or Cycle Sanitized light will not illuminate at the end of the cycle. Utilizing this option
will modify the cycle to meet the requirements of Section 6, of the NSF 184 Standard for soil
removal and sanitization efficacy.
NOTE: Certified residential dishwashers are not intended for licensed food establishments.
Dry
Off - Shuts off the drying option. Dishes air dry naturally and energy is saved. Open the
dishwasher door to speed drying.
On/Normal -Turns on the option for faster drying. This option may extend the time to your wash
cycle up to 85 minutes. This option is not available with the Rinse/Express cycle.
Ultra (on some models) -This option can be selected by pressing the Dry pad twice to illuminate
the Ultra light. It will add additional time to your drying option, further enhancing the dishwasher's
performance for difficult to dry items.
Steam
For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected
(Prewash)
PRIOR to starting the cycle. The Steam option adds up to 30 minutes to the cycle time. This
(on some
option is available with Pots, Auto, and Normal cycles.
models)
Pre Soak
Use this option to improve wash performance with heavy or dried-on soils. This option is
(on some
available on Pots, Auto, and Normal cycles and may add up to 30 minutes to the cycle time.
models)
Wash
Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
Zones
will shorten the cycle time and conserve energy. This option should be used when dishes are
(on some
placed in only one rack.
models)
Bottle Jets
This option increases the time that the bottle jets are on and may add up to 23 minutes to the
(on some
cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
models)
coffee cups, etc. See use recommendations in the
Delay
Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay, to select
the number of hours, then press Start one time and close door to begin countdown. The cycle
will start once allotted time has expired.
Control
You can lock the controls to prevent selections from being made. You can also lock the
Lock
controls after you have started a cycle to prevent cycle changes. For example, children cannot
accidentally start the dishwasher by pressing pads with this option selected.
To LOCK the dishwasher control,
controls for 3 seconds.
To UNLOCK the dishwasher control,
controls for 3 seconds.
8
press and hold the Presoak+Sani pad indicated on the
The Control Lock light will turn on to indicate the control is locked.
press and hold the Presoak+Sani pad indicated on the
The Control Lock light will turn off to indicate the control is unlocked.
Loading
section.
49-4000271 Rev 1

Advertisement

Table of Contents
loading

Table of Contents