Table of Contents
Advertisement
SETTING OVEN CONTROLS
SETTING TIMER
The TIMER ON . OFF pad controls the Timer feature. The
Timer serves as an extra timer in the kitchen that will beep
when the set time has run out. It does not start or stop
cooking. The Timer feature can be used during any of
the other oven control functions. Refer to "Minimum and
Maximum Control Pad Settings" for time amount settings.
To set the Timer (example for 5 minutes)
1. Press TIMER ON . OFF. "-- --" will appear in the
display.
2. Use the number pads to set the desired time in the
display; press 5.
3. Press START. The time will begin to count down with
"5:00" in the display.
Note: If START is not pressed the timer will return to the
time of day after 25 seconds.
4. When the set time has run out, "End" will show in
the display. The clock will sound with 3 beeps every 5
seconds until TIMER ON . OFF is pressed.
To cancel the Timer before the set time has run
out
1. Press TIMER ON . OFF. The display will return to the time
of day.
SETTING + 1 MIN FEATURE
The + 1 MIN pad is used to set the Add 1 Minute feature.
When the + 1 MIN pad is pressed, 1 minute is added to the
Timer feature if this feature is already active. If the Timer
feature is not active and the + 1 MIN pad is pressed, the
Timer feature will become active and will begin counting
down from 1 minute.
16
SETTING LOCKOUT FEATURE
The
pad controls the Lockout feature. The Lockout
feature automatically locks the oven doors, the control
panel and the cooktop. It does not disable the Minute
Timer or the interior oven lights.
To activate the Lockout feature
1. Press and hold
for 3 seconds.
2. After 3 seconds "Loc" and "Control" will appear, a
beep will sound, "UPPER", "LOWER" and "DOOR" will
fl ash in the display. Once the oven door is locked the
"DOOR" will stop fl ashing and remain on along with
the "Loc", "Control" and the
To reactivate normal operation:
1. Press and hold
for 3 seconds. A beep will sound.
The "UPPER", "LOWER" and "DOOR" will fl ash in the
display until the oven door has completely unlocked and
the
icon will disappear.
2. The unit is again fully operational.
NOTE
The surface elements cannot be activated when the
Lockout feature is active (see the section: The electronic
surface element control (ESEC)).
icon will appear.
Advertisement
Table of Contents
