Advertisement
Assembling the Outdoor Housing
●
For the built-in heater and fan in the dome cover, you need an additional 24 V AC power supply.
●
This housing is used in combination with a dome cover (clear/smoked) and a mounting bracket (wall/
pendant) that are sold separately.
☞
For how to install an assembled housing, refer to the instruction manual for the bracket used.
Also refer to the instruction manual for each associated device.
1. Attaching the dome cover
1
Hook the safety wire (A) of the dome cover on hook
hole (A') located inside the housing.
2
Connect the heater cable (B) to the heater terminal
(B') and the fan cable (C) to the fan terminal (C').
B
B'
A'
C'
2. Mounting the power board unit
1
Pass the supplied screws
unit screw holes (D) and fasten them loosely using
washers
(4 places).
2
Mount the power board unit in the housing aligning
the arrows (E) of the same color (blue) on them,
and then firmly tighten the screws
fastened in the previous step.
• Make sure the terminal (F) and its cable are located
along the inner lateral face of the housing.
• Pull the video cable led from the ceiling or wall
toward the power board unit.
Power Board Unit:
D
VA-84S/80S
D
D
E; Blue
3
Fix the housing onto the mounting bracket (wall/
pendant).
☞ For details, please refer to "Outdoor Type" in the
Mounting Bracket Instruction Manual.
C
A
Dome Cover:
• VA-CM8C (Clear)
• VA-CM8S (Smoked)
through power board
loosely
Video cable
D
a
b
F
3. Connecting cables
1
Connect the 24 V AC power cable to the terminal (F).
2
Connect other cables to the power board unit.
☞ For details, please refer to "Connections and Settings"
in the Installation Manual that comes with the camera
unit.
4. Mounting the camera unit
1
Fasten the camera unit safety wire (G) to the hook
(G') inside the power board unit.
2
Align the arrows (E) of the same color (blue) on the
camera unit and the housing inner face, and push
the camera until you hear a click.
3
Remove the plastic cover (H) of the camera unit.
4
Attach the dome cover by fastening 4 screws (J)
using the supplied hexagonal wrench.
G
*
H
* To remove the camera unit
2
F
*
J
J
J
G'
E; Blue
J
Advertisement
