FUTABA CPS-1 Instruction Manual

Before using your new CPS-1, please read this manual
thoroughly and use the system properly and safely.
After reading this manual, store it in a safe place.
Channel Power Switch
Thank you for buying a CPS-1 Channel Power
Switch.
When illumination (LED
the fuselage, the LEDs can be turned ON/OFF
while running by using this CPS-1 unit to connect
to a vacant switch channel. The CPS-1 can also
be used to control ON/OFF of wing lights (LED),
etc. to increase the visibility of an airplane or
INSTRUCTION
helicopter fuselage.
MANUAL
*1
The CPS-1 comes with two dedicated high-brightness LEDs (w/connector)
*2
To control ON/OFF, a vacant switch channel is necessary at the system being used.

Usage Precautions

WARNNG
When 5 or more LEDs, etc. are
connected, the CPS-1 can be used
within a range over which the
maximum current (200mA) is not
exceeded. Also be careful of the
wiring because it is easily affected
by noise. It may cause erroneous
operation.
Use the CPS-1 within a range
ov e r w h i ch t h e t o t a l c u r r e n t
consumption including the servos
does not exceed the ESC regulator
capacity. It may cause erroneous
operation.

[CPS-1 Ratings]

power supply.
*1
) is mounted to dress up
<Other precautions>
CPS-1 may not
CPS-1
Futaba Corp. will not be responsible
for damage caused by combination
with other than Futaba Genuine parts.
CPS-1
*2

Connection

1
CPS-1
2
connector.
* Connect LEDs as required.

Meaning of Special Markings

Pay special attention to safety where indicated by the following marks:
DANGER
WARNING
CAUTION
Look through our comprehensive collection of rc toys right away.

Usage Method

channel output connector.
LED-1
Trans itter setting
1
CPS-1
* When the neutral position has been
shifted substantially by sub trim, etc.,
normal ON/OFF operation may not be
possible.
LED-2