Connecting Via Wps (Pbc Mode) - Canon WFT-E6 Instruction Manual

Connecting via WPS (PBC Mode)

The instructions in this chapter are continued from page 27.
This is a connection mode available when using an access point
compatible with WPS. In pushbutton connection mode (PBC mode), the
camera and the access point can be connected simply by pressing the
WPS button on the access point.
If multiple access points are active in the surrounding area, it may be

more difficult to establish a connection. In such a case, try using
[WPS (PIN mode)] to establish a connection.
Check the position of the WPS button on the access point in advance.

It may take approx. one minute to establish a connection.

28
Select [Connect with WPS].
1
Select [WPS (PBC mode)].
2
Select [OK] and press <0> to go to

the next screen.
Connect to the access point.
3
Press the access point's WPS button.

For details about where the button is
located and how long to press it, refer
to the access point's instruction
manual.
Select [OK] and press <0> to

establish a connection with the
access point.
 When a connection with the access
point is established, the [IP address
set.] screen (p.34) is displayed.