Picket House Furnishings CEL100ETE Assembly Instruction

Caution: Please read instructions thoroughly before unpacking assembly parts.Sharp,exposed staple tips can
cause injury,therefore,for your protection,please remove any exposed staples used in packing.
We recommend that you should assemble this product with the assistance of another person;this will make
1.
assembly easier, and will help to eliminate damage to the product or injury to persons during assembly.
Be sure to check all packing materials carefully for small parts that may have come loose inside the carton
2.
during shipment.
3. Please do not over tighten screws or bolts.
4. Please Put all parts on a non-abrasive floor before assembly, and follow the assembly steps to assemble your
newly purchased product correctly and efficiently.
PART LIST
No. PART DESC
A TEMPERED GLASS TOP
B
LEG
C BASE
D
METAL RING
NOTES ： Do not fully tighten any bolts until last step.
STEP : 1
C
Assembly Instruction for
END TABLE
CEL100ETE
CODE. Q'TY
NO.
1
1
2
PCEL100ETLEGNT 4
3
PCEL100ETBASNT 4
1
5
1
6
4
B
MADE IN VIETNAM
HARDWARE LIST
HARDWARE DESC
ALLEN BOLT (5/16"x 50mm)
SPRING WASHER(5/16")
FLAT WASHER (5/16"x 19mm)
ALLEN KEY(M5)
SCREW (Ø8*38mm)
SUCTION CUP
TOOLS REQUIRED (NOT PROVIDED)
3
2
1
CODE. Q'TY
8
8
PCEL100ETHWNT 8
1
4
PCEL100ETCUPNT 4
Phillips Screw Driver
PAGE 1 OF 2