Changing The Water Filter - Samsung RF4289HARS User Manual

cHANGING THE WATER FILTER

To reduce risk of water damage to your
property DO NOT use generic brands of
WARNING
water filters in your SAMSUNG Refrigerator.
USE ONLY SAMSUNG BRAND WATER
FILTER. SAMSUNG will not be legally
responsible for any damage, including, but
not limited to property damage caused by
water leakage from use of a generic water
filter. SAMSUNG Refrigerators are designed
to work ONLY WITH SAMSUNG Water Filter.
The Water Filter status icon on the Home
screen enables you to check the filter current
status of the water filter.
The Filter icon turns red to let you know when it
is time to change your water filter cartridge.
To give you time to get a new filter, the red icon comes
on just before the capacity of the current filter runs
out. Changing the filter on time provides you with the
freshest, cleanest water from your refrigerator.
1. Shut off the water supply. Then, turn the water
filter ( 1 ) about 1/4 turn, counter-clockwise.
2. Pull the water filter ( 1 ) from the case filter ( 2 ).
• To change the water filter more easily, shut
off the water supply valve.
• Sometimes, it is hard to disassemble the water
filter because impurities in the water cause it to
stick. If you are having difficulties, grip the water
filter firmly and pull it hard.
• When you pull the water filter, a little water can
leak from the opening. This is normal.
To minimize the water leaks, keep the filter
cartridge horizontal when you pull it.
• To prevent overflow, empty the water tray filter ( 3 )
and dry around of case filter ( 2 ).
3. Insert the new filter into the
filter case ( 4 )
4. Push the filter, and then turn
it clockwise until it locks.
• If you are in trouble of inserting the water
filter as high pressure of water, shut off the
water supply valve.
70_ operating
• The locked symbol should be lined up with the
indicator line.
5. When the replacement is done,
touch and hold the 'Reset the
water filter' simultaneously for 3 or
more seconds at the center of the
screen. (Refer to page 56)
(Red)
6. If you turned off the water supply, turn it back on.
For a replacement water filter, you can visit your
local home Improvement center or contact the
Samsung Parts distributor.
Be sure the replacement water filter has the
2
SAMSUNG logo on the box and on the water
filter.
Link : http://www.samsungparts.com
1
Removing any residual matter inside the water
supply line after installing the water filter.
1. Turn ON the main water supply and supply water
from water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.
3. Additional flushing may be
required in some households.
4. Open the Refrigerator door and
make sure there are no water
leaks coming from the water
filter.
2
Be sure to flush the dispenser thoroughly,
3
otherwise water may drip from the dispenser.
This means that there is still air in the line.
4