Sumitomo TYPE-72C+ Quick Reference Manual

TYPE-72C
Quick Reference Guide
■Home screen
Splice program Heater program
Display the Settings panel
Power source type
Change image view
Display/Non-display icons
Start the splicing process
Start the arc test
■Settings panel
To display the Settings panel, tap the
Settings panel icon (
Wireless LAN SD Power Time
Home Screen icons
) on Home screen.
Settings panel icons
Display the menu screen.
Set up Splice Program.
Set up Heater Program.
Play Help Videos.
Log in to Administrator
mode by entering passcode.
Adjust the volume.
Heater 2
Heater 1
Heater 2
Heater 1
Heater panel Heater 2
Heater 1
Control panel
Start the heating process on heater 1 and 2
View splice data after splicing
Adjust the zoom of a fiber image
Adjust display brightness
Adjust the focus of a fiber image
Capture a fiber image
■New Technology
NanoTune™
The splice error prevention system
While splice program is selected to "AUTO
NanoTune", the NanoTune
cleaved fiber surface and then sets up optimal
splice condition.
When the NanoTune™ is applied to poor fiber end face, a
NanoTune™ screen appears. Even in AUTO NanoTune program,
the NanoTune™ is not applied to good end face, and the usual
splice screen is displayed.
Using Keypad
Start and cancel Power ON/OFF
heating cycle
analyzes the
™
Reset
Set