Garmin nuvi 2310 Owner's Manual page 69

My battery gauge does
not seem accurate.
How do I know my
device is in USB mass
storage mode?
The device is
connected to the
computer, but it will not
go into mass storage
mode.
I cannot see any new
removable drives in my
list of drives.
My phone will not
connect to the device.
nüvi 2200/2300 Series Owner's Manual
Allow the unit to fully discharge, and fully charge it
(without interrupting the charge cycle).
When your device is in USB mass storage mode, a
picture of a device connected to a computer is shown
on the device screen. Also, you should see two new
removable disk drives listed in My Computer.
1. Disconnect the USB cable from your computer.
2. Turn off the device.
3. Plug the USB cable into a USB port on your
computer and into your device.
The device automatically turns on and goes into
USB mass storage mode.
4. Verify your device is connected to a USB port and
not a USB hub.
If you have several network drives mapped on your
computer, Windows can have trouble assigning drive
letters to your device drives. Refer to your operating
system Help file to learn how to map or assign drive
letters.
• From the main menu, touch Tools > Settings
> Bluetooth. The Bluetooth field must be set to
Enabled.
• Turn on your phone and bring it within 33 feet of
the device.
• Go to www.garmin.com/bluetooth
Appendix
for more help.
65