Table of Contents
Advertisement
1. Blades front to rear
2. Outside cutting edges
Leveling from Side to Side
1.
Move to the left side of the machine.
2.
Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to
Adjusting the Anti-Scalp Rollers (page
3.
Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page
24).
4.
Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets
(Figure
5.
Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck
(Figure
62).
Figure 61
3. Measure from the tip of the
blade to the flat surface
here.
Adjusting the Height of Cut
62).
g296914
1. Wood block—6.6 cm
(2-5/8 inches) thick
6.
Remove the hairpin cotter and washer from the
lower lift-arm pin
25).
1. Height-of-cut plate
2. Hairpin cotter
7.
Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
44
Figure 62
2. Wood block—7.3 cm
(2-7/8 inches) thick
(Figure
63).
Figure 63
3. Washer
(Figure
64).
g298028
g294197
Advertisement
Table of Contents
