Description - Echo CS-3000 Operator's Manual

1. Air cleaner cover - Covers air filter.
2. Front hand guard - Guard between the front handle and
the saw chain for protecting the hand from injuries and
aiding in control of the chain saw if the hand slips off the
handle.
This guard is used to activate the chain brake which is to
stop the saw chain rotation.
3. Throttle latch - Device for temporality setting the throttle
in a partially open position to aid starting.
4. Rear handle (for the right hand) - Support handle
located on the top of the engine housing.
5. Clutch cover - Protective cover to the guide bar, saw
chain, clutch, sprocket and silencer when the chain saw
is in use.
6. Chain catcher - A projection designed to reduce the risk
of the operator's right hand from being hit by a chain
which has broken or derailed from the guide bar during
cutting.
7. Guide bar - The part that supports and guides the saw
chain.
8. Chain - Chain, serving as a cutting tool.
9. Purge bulb (primer pump) - When starting engine, push
primer pump 3 or 4 times.
10. Choke control knob - Device for enriching the fuel / air
mixture in the carburettor to aid cold starting.
11. Front handle (for the left hand) - Support handle
located at the left side of the engine housing.

Description

12. Fuel tank cap - For closing the fuel tank.
13. Starter handle - The grip of the starter, for starting the
engine.
14. Oil tank cap - For closing the oil tank.
15. Lifting hook - If working off the ground the operator must
be trained in safe climbing techniques and use of all
recommended safety equipment.
16. Safety decal - Part number;
17. Ignition switch - Device for connecting and
disconnecting the ignition system and thus allowing the
engine to be started or stopped.
18. Throttle trigger lockout - A safety lever which must be
depressed before the throttle trigger can be activated in
order to prevent the accidental operation of the throttle
trigger.
19. Throttle trigger - Device activated by the operator's
finger, for controlling the engine speed.
20. Operator's manual - Included with unit.
Read before operation and keep for future reference to
learn proper, safe operating techniques.
21. Tools - 10 x 19 mm T-wrench (combination screwdriver
/ spark plug socket), small screwdriver.
22. Guide bar cover - Remove device for covering the guide
bar and saw chain during transport and other times when
the chain saw is not in use.
14
: X524-002100
: X524-002130