D) Fm Operation - Renkforce RF-DAB-Mono1 Operating Instructions Manual

Calling station information
• Push the button MENU (7) briefly to display various information on the station you just
listened to in the second line of the display (4).
• Push the MENU button (7) once more to move to the next display.
• The contents of the displayed information depend on the station.
Further operating options can be found in the menu
• Push the button MENU (7) for a longer time to display the menu.
• The following menu items refer to DAB operation.
Full scan
Manual tune
DRC
Prune

d) FM operation

Station search
• Push the button PREV. (3) or NEXT (8) briefly to change the reception frequency in steps
and manually. Every push of a button changes the reception frequency in steps of 50 kHz.
• Push the button PREV. (3) or NEXT (8) long to start the station scan into the corresponding
direction.
• If a FM transmitter with sufficiently strong signal is found, the scan stops and the transmitter
is played back.
Please set weaker stations by manual station selection.
Use the menu to set if the automatic station scan is to find only strong stations or all
stations. Scanning for all stations may lead to the station scan stopping after every
frequency stop in some broadcasting areas. In this case, set the search setting to
strong stations only.
34
Performs a scan (same function as when pushing the button SCAN (5)
Manual selection of the transmission frequency with display of the
signal strength
This function compresses playback of sound to make low sounds
better audible at a low volume or loud environment.
There are three compression rates available.
Deletes inactive stations from the station list