Klarstein SHIRLEY 15 UNO Manual page 24

EN
24
COMMISSIONING
Before first use
Remove all packing material. Allow the appliance to stand upright for at least
4 hours before plugging the power plug into the wall socket. This reduces the
possibility of malfunction due to improper handling during transport. Clean the
internal surfaces with lukewarm water and a soft cloth.
Before switching on
• Make sure that the machine is installed by a qualified person, following the
operating instructions.
• After installing the machine, wait four hours before plugging the power
plug into the wall outlet. This will allow the refrigerant to be completely
redistributed in the refrigerant circuit.
• Before using the machine for the first time, clean the exterior of the machine
and the removable accessories with a mild soap solution and water.
• Clean the inside of the appliance with a solution of sodium bicarbonate and
water. After cleaning, dry the inside of the appliance and the accessories
properly.
• When you turn on the machine for the first time, a strange smell may appear.
This is normal and the smell disappears as soon as the unit starts to cool
down.
During first use
Note: When you use the unit for the first time or switch it on again after a long
period, there may be a difference of a few degrees between the temperature
you set and the temperature displayed on the screen. This is normal. If the unit
has been switched on for a few hours, the temperature will adjust.
• The first time you switch on the unit, the compressor of the unit runs
continuously until the unit has cooled down.
• The appliance door should be opened as little as possible during the cooling
down process.
• If the unit has been switched off or the mains plug has been removed from
the socket, you should wait at least 5 minutes before switching it on again or
plugging the mains plug back into the socket.