Uniden UC100B/DC User Manual

Uniden UC100B/DC User Manual

Advertisement

Quick Links

UNIDEN SECURITY CLOUD

IMPORTANT SAFETY INSTRUCTIONS

• Do not connect multiple devices to a single power adapter. The
adapter may overload and cause overheating or a fire hazard.
• Verify the power supply voltage is correct before using the camera.
• Position the power supply where it will not come in contact with liquid.
Keep it dry.
• Do not drop the camera or subject it to physical shock.
• Do not aim the camera at the sun or other bright places. Doing so may
affect sensor life.
• It is the installer's and/or end user's responsibility to properly configure
security settings.
CAMERA USER MANUAL
Compatible Models - UC100B/DC
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UC100B/DC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Uniden UC100B/DC

  • Page 1 UNIDEN SECURITY CLOUD CAMERA USER MANUAL Compatible Models - UC100B/DC IMPORTANT SAFETY INSTRUCTIONS • Do not connect multiple devices to a single power adapter. The adapter may overload and cause overheating or a fire hazard. • Verify the power supply voltage is correct before using the camera.
  • Page 2 Surveillance laws very by state and local jurisdictions. Check all relevant laws in your area before using this product to ensure that your use is in compliance with applicable laws. Uniden is not liable in the event that this product is used for illegal purposes.
  • Page 3 REAR DESCRIPTION DESCRIPTION Mounting Base Memory Card Slot Back Case Power Supply Interface Sun Shield 10/100M Self- Adaptive Ethernet Interface Lens PoE Cable Adjusting Nut GND Screw WPSS/RESET Button INSTALLATION CONSIDERATIONS • Make sure the device in the package is in good condition and all the assembly parts are included.
  • Page 4 • Do not place the camera in areas where it will be exposed to extreme heat or cold. Operating temperature range is -22°F to +140°F (-30°C to +60°C). To prevent IR reflection: • Dust or grease on the camera lens will cause IR reflection. If there is dust or grease on the lens, clean it with clean soft cloth and isopropyl alcohol.
  • Page 5 2. Drill the screw holes into the ceiling according to the drill template. 3. Route the cables and fix the mounting base on the ceiling with three screws (included). 4. Adjut surveillance angle. Loosen one tilting adjustment screw and adjust as needed. Tighten the screw. COMPLIANCE FCC PART 15 The equipment has been tested and found to comply with the limits...
  • Page 6 à l’utilisateur de faire fonctionner cet équipement. Tout changement ou modification doit être approuvé par écrit par Uniden. Avis de conformité à la FCC : Ce dispositif a été testé et s’avère conforme à l’article 15 des règlements de la Commission fédérale des communications (FCC).
  • Page 7 Uniden service center for a defect or malfunction covered by this warranty, (E) used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden, or (F) installed or programmed by anyone other than as detailed by the...
  • Page 8 & a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor at: Uniden America Service C/O Saddle Creek 743 Henrietta Creek Rd., Suite 100 Roanoke, TX 76026...

Table of Contents