Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Uniden App Cam Solo 4G 2K
Summary of Contents for Uniden App Cam Solo 4G 2K
- Page 1 App Cam Solo 4G 2K Quick Start Guide...
-
Page 2: What's In The Box
What’s in the Box App Cam Solo Outdoor Security Rechargeable Silicone Weatherproof 4G 2K Mount Battery Cover Micro USB Mounting Mounting Screw Kit Reset Needle Cable Hole Template Strap The camera and the rechargeable battery are packed separately in the same package. Please dress the camera with the Silicone Cover for better weatherproof performance when you install the camera outdoors. -
Page 3: General Introduction
General Introduction Built-in Mic Infrared Lights Daylight Sensor Lens Status LED Built-in PIR Sensor Speaker Micro USB Port Micro SD Card Slot SIM Card Slot Reset Hole *Press the Reset button with a Pin to restore factory settings. Battery Status LED... -
Page 4: Install The Sim Card And Battery
Install the SIM Card and Battery 1. Rotate the back cover counterclockwise, 2. Insert the battery into the camera and insert the SIM card into the slot. tighten the back cover. • Tips for SIM Card SIM card requirements: • The SIM card should supports WCDMA and LTE networks. •... - Page 5 Register Online (Camera Initial Setup) 1. After the SIM card and battery are 2. A blue LED will flash for some sec- installed, a red light will be on, and you onds and then go solid before going out, will hear the voice prompt “Camera is you would hear “Network connection starting up, please wait”.
- Page 6 Note: You may also run into the below situations: Voice Prompt LED Status Camera Status Solution 1.Check whether you made a reverse Camera cannot “SIM card direction of SIM card cannot be recognise this Red LED is recognized!” SIM card 2.Check if the SIM card is not fully insert- solid on for some ed, please insert it again...
- Page 7 Setup Camera on Uniden Solo App There are two ways to get the Uniden Solo App: • Search “Uniden Solo” in App Store (for iOS), download and install the app. • Search “Uniden Solo” in Google Play 12:00 12:00 12:00...
- Page 8 3. After you created a password for your camera, please follow the steps to sync the time, and then start live view or go to “Device Settings” 12:00 Menu Solo 4G Add New Device Enable/Disable PIR Motion Sensor (the PIR sensor is enabled by default) Device Settings Access Live View Battery Status...
- Page 9 Attention for Camera Installation • PIR Sensor Detecting Distance The PIR senor has 3 sensitivity levels for your adjustment: Low/Mid/High. Higher sensitivity offers longer detecting distance. The default sensitivity of the PIR sensor is at “High”. Detecting Distance Detecting Distance Sensitivity Value (For moving and...
- Page 10 Important Notes for Reducing False Alarms For reducing false alarms, please note that: • Do not install the camera facing any objects with bright lights, including sunshine, bright lamplights, etc. • Do not place the camera too close to a place where there are frequently moving vehicles.
- Page 11 Cover the Monitoring Area When installing the camera, please install the camera angularly (the angle between the sensor and the detected object is larger than 10°) for effective motion detection. If the moving object approaches the PIR sensor vertically, the sensor may not detect the motion events.
-
Page 12: Charge The Battery
Charge the Battery It is recommended to full charged the camera before mounting the camera outdoors. There are three ways you can charge the battery: 1. Charge the battery when it's 2. Charge the battery separately. 3. Charge the camera with the installed to the camera. - Page 13 Important Safeguards on Rechargeable Battery Use App Cam Solo 4G 2K is not designed for 24/7 full capacity running or around-the-clock live streaming. It’s designed to record motion events and remotely view live streaming only when you need it. 1. Please charge the rechargeable battery with a standard and high-quality DC 5V or 9V battery charger.
-
Page 14: How To Mount The Camera
How to Mount the Camera Drill holes in accordance with a mounting hole template and screw the security mount into the wall. If you are mounting the camera on any hard surface, insert plastic anchors into the holes first. Install the camera on the To get the best field of view, Stiffen the adjustment knob security mount. - Page 15 How to Attach the Camera to a Tree Thread the provided strap Attach the plate to the security Fasten the security mount to the mounting plate. mount with the smaller screws. to a tree. Install the camera and adjust the camera angles as instructed in step 2 &...
-
Page 16: Specification
Specification Model App Cam Solo 4G 2K Image Sensor 1/3” CMOS Image Sensor Display Resolution 2560 x 1440 (4.0 Megapixel) Angle of View Diagonal: 110° PIR Detecting Distance Up to 10m PIR Detecting Angle Horizontal: 120° Hardware Features Minimum Illumination... - Page 17 Frequency Bands B1/B5(AUV)@WCDMA, B1/B3/B5/B7/B28@LTE 3G/4G Transmission Data HSPA+: Max 14.4Mbps (DL)/Max 5.76Mbps (UL), LTE CAT1: Max 10Mbps (DL)/Max 5Mbps (UL) Type Specification Lithium battery/3.6V, 7800mAH, Supports Solar Power Battery Battery Level Indication Battery Life Up to 3 Months in Standby Mode with one detection a day Temperature Operating Temperature : -10C~+55C Other Parameters...
-
Page 18: Warranty
Accessories and Battery 90 Days If a warranty claim is made, this warranty will not apply if the Product is found by Uniden to be: A. Damaged or not maintained in a reasonable manner or as recommended in the relevant Owner’s Manual;... - Page 19 Product does not conform with this warranty, you should deliver the Product, together with satisfactory evidence of your original purchase (such as a legible copy of the sales docket) to Uniden. Please refer to the Uniden website for address details. You should contact Uniden regarding any compensation that may be payable for your expenses incurred in making a warranty claim.
- Page 20 THANK YOU FOR BUYING A UNIDEN PRODUCT © 2022 Uniden Australia Pty Limited V1.0 Printed in PRC...
Need help?
Do you have a question about the App Cam Solo 4G 2K and is the answer not in the manual?
Questions and answers
How can I reset my device password when I do not have the original password.