Advertisement
Toner that doesn't cost the earth
Printed on recycled paper, using refilled cartridges
Low Yield gear (TN2210) replace as shown opposite.
The arrow with the number 3 should be pointing
in the direction shown
Note that the gear teeth are not meshed when set,
which is how it should be. The gear is spring loaded
and will turn when driven by the printer
HIGH Yield gear TN2220 replace the gear as shown
opposite.
The arrow with the number 1 should be pointing
in the direction shown
Note that the gear teeth are not meshed when set,
which is how it should be. The gear is spring loaded
and will turn when driven by the printer
Both gears: Note the position of the straight edge
(shown in yellow) of the agitator gear.
This position is required to properly reset the printer.
With the gear set in the correct position, re-install the
gear cover plate and replace the two screws as shown
opposite.
© Zinetic.co.uk. All Rights Reserved
Advertisement
