Advertisement
1 Switch printer off.
3 Locate the hopper
cap on your
cartridge. Normally
hidden behind the
label
5 WARNING: You must ensure all toner is
dumped from your cartridge before refilling with
the new toner. You must do this every refill.
Brother cartridges can leave as much as 25 grams of
waste toner in the cartridge, while reporting toner
empty/refusing to print. Important - mixing new and
old toner will cause print defects to occur.
6 Shake your bottle
of new toner
vigorously for 30
seconds BEFORE
removing the cap.
Remove the cap and
seal from the bottle
8 Insert the spout
into the hole. The
toner will flow out
like water, so take
care not to spill it.
10 Replace the cap
in your toner
cartridge, using the
new plug provided.
2 Remove cartridge from printer. Place printer
cartridge on several sheets of newspaper.
4 Remove the
hopper cap using
needle nose pliers,
or a flat blade
screwdriver to lever
out the hopper cap.
Empty in an area
that can tolerate a
toner spill i.e. your
garage.
Toner can be very
messy - empty the
old toner directly
into a large bin bag.
7 Fit the toner
pouring spout
securely to the
bottle.
Spouts are
reusable.
9. With the spout
inserted – carefully
"Upend" the
cartridge and allow
the toner to slowly
pour into the
cartridge.
11 Gently rock the cartridge from side to side to
distribute the toner in the cartridge. Wipe away any
excess toner from around the plug.
Reset the cartridge using the instruction on the
following page. When successfully reset - replace the
cartridge and print some test pages to remove any
excess toner.
© Zinetic.co.uk. All Rights Reserved
Toner that doesn't cost the earth
Printed on recycled paper, using refilled cartridges
Advertisement
