INSTRUCTIONS FOR REFILLING BROTHER TN 2210 & TN2220 (EUROPE)
BROTHER DCP-7060D, DCP-7065DN, DCP-7070DW, HL-2230, HL-2240, HL-2240D, HL2242, HL-
2270 DW, HL 2280DW HL2250, HL2250DN, MFC-7360N,MFC-7460 DN, MFC-7860DW.
When to refill: The Brother machine lets you know when you are low on toner using a series of LED lights
on the printer. You can force the printer to continue to print and use up as much toner as possible by selecting
the CONTINUE MODE.
Please read instructions from start to finish, before you start your refill.
How to select Continue
To force the machine to continue printing after the LEDs indicate REPLACE TONER, press Go seven times to
enter Continue mode (all the LEDs flash twice, and then the Ready LED turns on).
The machine will then continue printing until the LEDs indicate TONER ENDED
MFC / DCP version of the machine : To enable Continue Mode, please follow the steps below:
1. Press MENU and choose General Setup => Replace Toner.
2. Use the UP OR DOWN ARROW key to choose Continue and then press OK.
3. Press STOP/EXIT
(To return to the default setting (Stop mode), press Go seven times (all the LEDs flash once).
TONER LOW - The Toner LED will turn on for 2 seconds and off for 3 seconds -
ignore message - Keep printing
In "Stop mode" you would be required to empty and refill at this point.
However you can use the CONTINUE MODE to override this default setting and
print for longer see below.
mode:
Replace toner (CONTINUE MODE) – the toner light is on but you can continue to
print.
CONTINUE MODE - Toner Light on continuously with error light lit - machine will
not print – Empty it and Refill it (TONER ENDED)
You must now empty and refill.
© Zinetic.co.uk. All Rights Reserved
Toner that doesn't cost the earth
Printed on recycled paper, using refilled cartridges