Table of Contents
Advertisement
English
Versions with ErgoStart
WARNING
This machine is extremely simple and
easy to start, even for children – risk of
accidents.
Do not allow children or other
unauthorized persons to attempt to start
or otherwise use the machine:
Never leave the machine
–
unattended during work breaks.
After work, store the machine in a
–
safe, secure location.
The ErgoStart stores the energy
required to start the saw. For this reason
there may be a delay of a few seconds
between cranking the engine and it
actually starting.
There are two ways of starting with the
ErgoStart:
Hold the starter grip with your right
N
hand and pull it out slowly and
steadily – or – hold the starter grip
with your right hand and give it
several short pulls, using only a
short length of rope for each pull.
Push down the handle while
N
cranking. Do not pull out the rope to
its full length – it might otherwise
break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
32
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
Observe safety precautions.
N
Versions with manual fuel pump
Press the manual fuel pump bulb at
N
least five times – even if the bulb is
already filled with fuel.
All models
0
1
4
Push the hand guard (1) forward –
N
the chain is locked.
Press down the trigger lockout (2)
N
and pull the throttle trigger (3) at the
same time. Set Master Control
lever (4) to:
Choke shutter closed (l)
if the engine is cold (also use this
–
position if the engine stopped when
you opened the throttle after
starting)
Starting throttle position (n)
if the engine is warm, i.e. if it has
–
been running for about one minute.
Hold and start your saw as
N
described.
2
3
MS 251 C-Q
Advertisement
Table of Contents
