Table of Contents
Advertisement
Use the hook to attach the rear holder into the upper
3.
hole ‚ and push it into the lower hole ƒ (fig.
Attaching the rails
When hanging the rails, ensure that the pull-out is at the
bottom.
The rails only fit on the right or the left side. The pull-out
rails must pull out forwards.
Hold the rear of the frame at an angle and mount it
1.
at the top and bottom ‚ (fig.
Pull the rail forwards (fig.
2.
Then fold it forwards and insert it (fig.
3.
And push it downwards (fig.
4.
Completely reinsert the pull-outs.
5.
).
#
).
!
).
"
).
#
).
$
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.
Removing the door cover
The stainless-steel inlay in the door cover may become
discoloured. To carry out thorough cleaning, you can
remove the cover.
Open the appliance door slightly.
1.
Press on the right and left side of the cover (fig.
2.
Remove the cover (fig.
3.
Close the appliance door carefully
Clean the stainless-steel inlay in the cover with
Note:
a stainless-steel cleaning agent. Clean the rest of the
door cover with soapy water and a soft cloth.
Open the appliance door again slightly. Put the
4.
cover back in place and press on it until it clicks
audibly into place (fig.
Close the appliance door.
5.
Appliance door
).
"
).
#
en
).
!
31
Advertisement
Table of Contents
