Package Contents; Parts Description; Technical Specifi Cations; Safety Instructions - Parkside PSHP 1 A1 Operation And Safety Notes

 Package contents
1 Automatic welding helmet
1 set of operating instructions
 Parts description
1 Viewing pane
2
Helmet casing
3
Solar cell
4
Rear lens
5
Headband
6 Rear control dial headband
7
Lateral control dial headband
8
UV fi lter
9
Darkening control
10
Test button
11 Delay setting
12 Sensitivity setting
13
Low battery display
14
Battery compartment
15
Bracket
16 Arc sensor
17 Darkening switch
 Technical specifi cations
Filter cassette size:
Field of vision:
Light condition:
Dark condition:
Cycle times
Light to dark:
Dark to light:
Filter for switching
on/off:
Energy supply for
switching on/off:
UV/IR protection:
Operating temperature: -5 °C to +55 °C
Storage temperature:
Welding processes:
Maximum service life:
133 × 114 x 10 mm
102 x 93 mm
DIN 4
DIN 5 – DIN 9/
DIN 9 – DIN 13
0.23–0.72 ms
0.1–0.8 s
Fully automatic
Solar cell
DIN 16
-20 °C to +70 °C
MMA, MIG,
MAG, TIG, plasma
cutting and plasma
welding
approx. 5 years

Safety instructions

Please read the operating instruc-
tions with care and observe the
notes described. Familiarise your-
self with the device, its proper use
and the safety instructions using
these operating instructions.
The rating plate contains all tech-
nical data of this welding helmet;
please learn about the technical
features of this product.
Prior to each use, check that it

is working properly by pressing
the "Test" button.
The product is not suitable for

laser welding.
The product is only approved

for use within a temperature
range of between -5 °C to
+55 °C.
The product is not fi re-resistant.

The welding helmet and UV

fi lter must not be exposed to
any heat or moisture.
Do not remove the ADF fi lter

from the welding helmet and
never open the housing of the
ADF fi lter without authorisation
from the manufacturer.
Prior to each use, check

whether the Welding/Grinding
setting was selected correctly.
GB/CY 7