Parkside PSHP 1 A1 Operation And Safety Notes page 10

Improper use of the eye protec-

tion (injury, accident). The eye
protection device must only be
used for the work described in
the operating instructions.
Any deviation from the instruc-
tions can result in injuries or
accidents.
This device may be used by

children aged 16 years and
older, and by persons with
reduced physical, sensory or
mental capacities, or a lack of
experience and knowledge,
if they are supervised or have
been instructed in how to use
the device safely and under-
stand the dangers that may
arise when using it. Do not
allow children to play with the
device. Cleaning and day-to-
day maintenance must not be
performed by children without
supervision.
The welding helmet with

auto-darkening is not suitable
for laser and autogenous
welding.
Never place the welding

helmet on hot surfaces.
Do not open the welding helmet

under any circumstances.
Do not carry out any repair
work or alterations to the
welding helmet. This work must
10 GB/CY
only be carried out by trained
specialist personnel.
Before any welding work,

please make sure that you
have adjusted the auto-
darkening.
The safety visor must not be

opened. It protects the fi lter
from dirt and damage.
If the fi lter does not darken

automatically, stop the welding
work immediately and contact
the manufacturer.
Only use the welding helmet

at temperatures between -5°C
and +55°C. The response time
of the fi lter will slow down if
the temperatures go below/
above these temperatures.
Clean the fi lter, helmet surface

and the solar cells regularly.
Replace the protective visor if

it is showing signs of scratches
or damage.
The welding helmet does not

protect against impact.
Using, cleaning and storage

can reduce the service life of
approx. 5 years. If the viewing
pane is scratched or there is
other visible damage to the
viewing pane or the welding
helmet, replace immediately.