Defender HA00825 Manual

PRO-TEC KEY SAFE
Heavy Duty Push Button Key Storage

IMPORTANT!

Please read the following instructions carefully before installing your key safe. Always wear goggles or other suitable
eye protection before starting to drill.

CONTENTS

1 x Key Safe
1 x TPU cover to protect and disguise your key safe
4 x Thunderbolts for securely fixing your key safe

YOUR KEY SAFE

On the front of the key safe there are 12 buttons, numbers 1-0, plus letters A-B. There is also an 'Open' turn dial and a red 'Clear' catch .
The key safe is shipped from the factory without a preset combination. This means that the 'Open' turn dial will open the key safe
without any number buttons being pressed. NOTE: The key safe will not open if any of the numbers have been pressed.
If a button is pressed accidentally or incorrectly, slide the red Clear catch down. This clears the memory and resets all the number buttons.

BEFORE INSTALLING THE KEY SAFE

Select your own combination for the key safe.
As with all mechanical push button key safes, each number in a combination can only be used once.
It is recommended that you do not use a number combination that can be easily guessed. Avoid numbers linked to your telephone number
or birthday. Do not use a bank card PIN number as this may breach your financial security should someone determine the combination to
your key safe. Use a unique number that only you will know between four and six numbers inclusive.
Record it on the Combination Protector Card included; this should be safely stored so that in the unlikely event that you forget your
combination it can be located and used to access your keys.
WARNING:
Please note that if you forget your combination gaining access to your key safe is not covered by your warranty. There are no
master codes so the ONLY way to open the key safe is by using suitable tools and brute force.
Under no circumstances should you remove the screws on the inside cover of the lid. Your warranty will be void if tampered with.

SETTING YOUR COMBINATION

Step 1:
To set the combination for the first time, slide the Clear catch down to clear the memory and reset
the number buttons. Rotate the Open dial button 90° clockwise and pull open the lid. The top
of the key safe is conveniently hinged, take care so that the key safe door doesn't close on your
fingers. Whilst open, rotate the turn dial 90° anti-clockwise back to it's original position.
Step 2:
There are 12 metal dials, numbered 1-0 plus A-B, with red arrow indicators on the inner door.
There is no preset combination so all the red arrows should be facing towards the word RESET.
NOTE: these numbers correspond to the numbered buttons on the front of the lid.
Step 3:
Using the Combination Setting Key provided, set each digit of your combination. To do this, simply
place the Combination Setting Key into the metal dial, apply light pressure and rotate 180°.
The red arrow should now be facing towards the word SET. Repeat for each number in your com-
bination. Take care to line up each red arrow in the correct direction - 90° turn will not work.
DO NOT CLOSE THE KEY SAFE DOOR UNTIL YOU HAVE TESTED THE COMBINATION!
1 x Combination Protector Card with instructions
1 x Combination Setting Key
Product Code: HA00825
Metal Dial
Turn 180° so that the red
arrow points towards SET
SCAN TO WATCH THE
EASY INSTALLATION VIDEO!