Deltec TC 2000ix Operating Instruction page 15

open the water level adjuster (WAL) fully by turning it anti-clockwise (Diagram f)
-
switch on water supply through skimmer
-
adjust the water level inside the skimmer with the feed line shut-off cock and the WAL
-
to somewhere between the top and bottom of the skimmer neck, see (Diagram g)
check the skimmer for possible damage and check the whole skimmer installation for
-
leaks.
switch on the skimmer pump
-
to prevent initial over foaming and flooding of the skimmer cup, adjust the fine foam
-
level in the cup's riser tube to the bottom plate of the skimmer cup. This is achieved
by turning the WAL
wait a minimum of 24 hours for the final adjustment. Turn the WAL so that the fine
-
bubbles start bursting app. half way up the cup's riser tube.
for dry foam turn the (WLA) anti clockwise, for wet foam clockwise.
-
Important: Never allow the pump to run dry.
-
f) Water level adjuster (WAL)
Starting the skimmer
-15-
g) Skimmer cup