Husqvarna Z200 Operator's Manual page 13

a) Move the throttle control to the cold weather
position.
b) Push and turn the ignition key to the start
position.
Note:
Do not keep the ignition key in the
start position for more than 5 seconds at a
time. If the engine does not start, wait 15
seconds before you try again.
c) When the engine starts, immediately release
the ignition key to the neutral position.
d) Move the throttle control to the full throttle
position.
CAUTION:
move the throttle control to the
full throttle position, it can cause
damage to the product and
decrease the performance of the
engine.
7. Let the engine run at ½ throttle for 3-5 minutes
before you apply full throttle.
8. Push the throttle control to the full throttle
position.
To operate the product
1. Start the engine. Refer to
page 12 .
2. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 11 .
1550 - 003 - 11.08.2023
If you do not
To start the engine on
To
3. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
4. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
5. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
6. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
b) Pull the right control lever rearward in the
direction of the neutral position to make the
product turn right. The more you pull the right
control lever rearward, the more the product
will turn right.
7. Do the steps that follow to make a zero turn.
13