Table of Contents
Advertisement
Quick Links
Installation
Instructions
Questions? Call
1-800-944-9044(US)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
or
Save these
Observe all
Be sure to leave these
Over the Range
Microwave Oven
1-800-265-8352(Canada)
Note to Consumer –
•
instructions for future reference.
• Skill level – Installation of this appliance requires
basic mechanical and electrical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
KEEP THESE INSTRUCTIONS
Keep these
READ CAREFULLY.
p/n 316495
162
A
pril
201
.
7
Advertisement
Table of Contents
Related Manuals for Frigidaire FFMV1645TSA
Summary of Contents for Frigidaire FFMV1645TSA
- Page 1 Installation Over the Range Instructions Microwave Oven Questions? Call 1-800-944-9044(US) 1-800-265-8352(Canada) BEFORE YOU BEGIN Read these instructions completely and carefully. Note to Consumer – • Keep these instructions for future reference. IMPORTANT – • Save these • Skill level – Installation of this appliance requires instructions for local inspector’s use.
-
Page 2: Table Of Contents
Installation Instructions Adapting Microwave Blower CONTENTS – for Outside Back Exhaust....17 18 General information Mount the Microwave Oven ....19 Important Safety Instructions ........3 Recirculating ........– Electrical Requirements .......... 3 Attach Mounting Plate to Wall .... Damage – Shipment/Installation......4 Preparation of Top Cabinet ....2 Parts Included............ -
Page 3: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS This product requires a three-prong grounded outlet. You should have the wall receptacle and circuit checked The installer must perform a ground continuity check by a qualified electrician to make sure the receptacle is on the power outlet box before beginning the properly grounded. -
Page 4: Damage-Shipment/ Installation
Installation Instructions PARTS INCLUDED DAMAGE—SHIPMENT/ (CONT.) ADDITIONAL PARTS INSTALLATION PART QUANTITY • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair Cabinet or replacement. Template • If the unit is damaged by the customer, repair or replacement is the responsibility of the customer. -
Page 5: Tools You Will Need
Installation Instructions TOOLS YOU WILL NEED Ruler or tape measure and straight edge Pencil Carpenter square # 1 Phillips screwdriver (optional) Tin snips (for cutting damper, if required) Scissors “ “ “ Electric drill with ⁄ ⁄ ⁄ (to cut template, if necessary) drill bits Filler blocks or scrap wood pieces, if needed... -
Page 6: Placement Of The Mounting Plate
Installation Instructions PLACEMENT OF THE MOUNTING PLATE 4 Cut the middle of the outer protective plastic bag to remove the ounting late REMOVING THE MICROWAVE OVEN FROM THE CARTON/ Screws Screws REMOVING THE MOUNTING Mounting Plate PLATE Remove the installation instructions,use and care, exhaust adapter, turntable ring, shelf, filters, glass tray and the small hardware bag. -
Page 7: Determining Wall Plate Location
Installation Instructions DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET Plate position -beneath framed Plate position -beneath flat bottom cabinet bottom cabinet recessed NOTE: IT IS VERY READ AND FOLLO IMPOR IN THE W THE TANT BEFOR INSTA LLATIO DIREC REAR E PROCE N INSTR UCTIO... -
Page 8: Aligning The Wall Plate
Installation Instructions ALIGNING THE WALL PLATE 3/8" TO EDGE 12" NOTE: IT IS VERY IMPORTANT TO Trim the rear wall template along the dotted line. READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS REAR WALL TEMPLATE. This Rear Wall Template serves to position the bottom mounting plate and to locate the horizontal exhaust 4"... -
Page 9: Installation Types
Installation Instructions INSTALLATION TYPES (Choose A, B or C) This microwave oven is designed for adaptation to NOTE: This microwave is shipped assembled for the following three types of ventilation: Recirculating. Select the type of ventilation required for your installation and proceed to that section. - Page 10 Installation Instructions INSTALLATION INSTRUCTIONS FOR EXTERNAL EXHAUST DUCTING Maximum duct length: NOTE: If you need to install ducts, note that the total duct length of 3 ⁄ ” x 10” (8.2 x 25.4 cm) rectangular or For satisfactory air movement, the total duct length of 5”...
- Page 11 Installation Instructions EXTERNAL EXHAUST DUCTING OUTSIDE TOP EXHAUST (EXAMPLE ONLY) The following chart describes an example of one possible ductwork installation. EQUIVALENT NUMBER EQUIVALENT DUCT PIECES LENGTH USED LENGTH Roof Cap 24 Ft. (7.3 m) 24 Ft. (7.3 m) 12 Ft. (3.6 m) Straight Duct 12 Ft. (3.6 m) 12 Ft.
-
Page 12: Aoutside Top Exhaust
Installation Instructions OUTSIDE TOP EXHAUST (Vertical Duct) INSTALLATION OVERVIEW A1. Attach Mounting Plate to Wall A2. Prepare Top Cabinet Adapting Microwave Blower for Outside Top Exhaust A4. Check Damper Operation Mount Microwave Oven 3/8" TO EDGE Adjust Exhaust Adaptor along the dotted line. Trim the rear wall template 12"... -
Page 13: Preparation Of Top Cabinet
Installation Instructions USE TOP CABINET TEMPLATE Carefully pull out the blower unit. The wires FOR PREPARATION OF TOP will extend far enough to allow you to adjust the blower unit. CABINET End B You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. -
Page 14: Checking For Proper Damper Operation
Installation Instructions MOUNT THE MICROWAVE ADAPTING MICROWAVE OVEN BLOWER FOR OUTSIDE TOP EXHAUST Secure blower unit to microwave with the screw removed in Step 1. Make sure the screw is tight. Replace blower plate with the screw removed in Step 1. Make sure the screw is tight. FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. -
Page 16: Boutside Back Exhaust
Installation Instructions OUTSIDE BACK EXHAUST (Horizontal Duct) INSTALLATION OVERVIEW B1. Prepare Rear Wall B2. Remove Blower Plate B3. Attach Mounting Plate to Wall 3/8" TO EDGE along the dotted line. Trim the rear wall template B4. Prepare Top Cabinet 12" NOTE: IT IS VERY IMPORTANT THE DIRECTIONS READ AND FOLLOW... -
Page 17: Attach Mounting Plate To Wall
Installation Instructions ATTACH THE MOUNTING PLATE TO THE WALL • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the Attach the plate to the wall using toggle bolts. TOP CABINET TEMPLATE. -
Page 18: Adapting Microwave Blower For Outside Back Exhaust
Installation Instructions ADAPTING MICROWAVE Place the blower unit back into the opening. BLOWER FOR OUTSIDE AFTER: Fan Blade Openings Facing Back BACK EXHAUST (cont.) End A Rotate blower unit counterclockwise 180°. Before Rotation After Rotation End B CAUTION: Do not pull or stretch the blower unit wiring. -
Page 19: Mount The Microwave Oven
Installation Instructions Cabinet Front MOUNT THE MICROWAVE Cabinet Bottom Shelf OVEN Filler Block Equivalent to Depth of Cabinet Recess Self-Aligning Screw FOR EASIER INSTALLATION AND PERSONAL Microwave Oven Top SAFETY, WE RECOMMEND THAT TWO PEOPLE Attach the microwave oven to the top cabinet. INSTALL THIS MICROWAVE OVEN. -
Page 20: Recirculating
Installation Instructions RECIRCULATING (Non-Vented Ductless) INSTALLATION OVERVIEW C1. Attach Mounting Plate to Wall C2. Prepare Top Cabinet 3/8" TO EDGE along the dotted line. Trim the rear wall template C3. Check Blower Plate 12" NOTE: IT IS VERY IMPORTANT READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS... -
Page 21: Preparation Of Top Cabinet
Installation Instructions MOUNT THE MICROWAVE OVEN USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS MICROWAVE OVEN. -
Page 22: Charcoal Filter
Installation Instructions MOUNT THE MICROWAVE Open the microwave door and remove the two OVEN (cont.) vent mounting screws ; l ocated on top of the microwave using a #1 Phillips screwdriver. Insert 2 self-aligning screws Charcoal through outer top cabinet Filter holes. - Page 23 Installation Instructions For models with the recirculation filter access door ® follow these steps to replace or install a PureAir Microwave ilter. ® Remove the PureAir Filter from the packaging and shake filter to remove excess carbon. Use a Phillips head screwdriver to unscrew the ®...
- Page 24 Installation Instructions ® Place the new PureAir Filter into the slot behind the door at an angle until it's upright and securely placed in the duct. Make sure the PureAir ® Filter is nested vertically in the slot. Close access door,tighten screw ®...
-
Page 25: Before You Use Your Microwave
Installation Instructions BEFORE YOU USE YOUR MICROWAVE Make sure the microwave oven has been Replace house fuse or turn breaker back on. installed according to instructions. & Read the CARE Manual. Remove all packing material from the microwave oven. Install turntable ring a nd glas s tray in cavity. - Page 26 3/8" TO EDGE 12" Trim the rear wall template along the dotted line. NOTE: IT IS VERY IMPORTANT TO READ AND FOLLOW THE DIRECTIONS IN THE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING WITH THIS REAR WALL TEMPLATE. This Rear Wall Template serves to position the bottom 4"...