Summary of Contents for MTHTrains Railking FA-2 AA
Page 1
Railking FA-2 AA Diesel Engine Set OPERATOR’S MANUAL (3V PS-2) Compatibility This engine will operate on any traditional O-31 Gauge track system, including M.T.H.’s RealTrax® or ScaleTrax™ or traditional tubular track. Freight Yard Sound It is also compatible with most standard AC transformers.
Table of Contents Set Up Checklist..................Lubrication....................Checking the Battery..................Basic Operation.................... Activating Features..................Manual Volume Control................Proto-Sound 2.0 Operating Instructions........... Activating Proto-Sound 2.0 Conventional Mode Features......Freight Yard Sounds (FYS)/ Passenger Station Announcements (PSA).. Proto-Coupler® Operation................Speed Control....................Locking Locomotive Into A Direction............Reset To Factory Default................
If you notice that the sounds are garbled, test and charge the engine as described in the "Self-Charging Battery Back-Up" on page 14. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
The engine is programmed to restart in neutral each time the track voltage is turned off for 25 seconds or more. Cycle Phases Neutral Reverse Forward Neutral Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Manual Volume Control To adjust the volume of all sounds made by this engine, turn the master volume control knob located next to the fuel tank clockwise to increase the volume and counter-clockwise to decrease the volume. Volume Adjustment Knob Figure 2.
FYS/PSA. After about 30 seconds, press the Direction button again to trigger the third FYS/PSA sequence. Again, after allowing about 30 seconds for that sequence to run, press the Direction Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Horn/Whistle button, allowing approximately ½ second to lapse between each quick button press. The sound of the liftbar and air line depletion will play, and the knuckle will be released. Fire Horn/ Horn/ Horn/ Bell Rear Whistle Whistle Whistle Coupler Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
3 bells code to return the engine to its normal condition, even if the engine is kept without power for extended periods of time. Direction Lock Two Whistle Blasts whistle (indicates change is made) Repeat to Return to Normal Condition Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Cab Chatter plays at random intervals when the engine idles in neutral. Engine Start-up and Shut-down sounds play when the engine is initially powered on or is powered off for five seconds or more. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
3. Once the motor mount screw has been removed, pull the motor away from the truck block and lightly coat the motor worm gear and bronze drive gear (in the truck block) with grease. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Thereafter, keep an eye on the track and clean it when it gets dirty to ensure good electrical contact and to lengthen the life of the tires. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
One set of replacement tires is packaged with the model. Additional tires are available directly from the M.T.H. Parts Department (phone: 410-381-2580; fax: 410-423-0009; e-mail: parts@mth-railking.com; mail: 7020 Columbia Gateway Drive, Columbia MD 21046-1532). Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Carefully remove bulb(s) from mounting. Disconnect light bulb harness from main wire harness. Replacement bulb harnesses are available directly from the M.T.H. Parts department. Connect replacement bulb harness and reassemble in reverse. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Replace: If the sounds are not improved at the end of the 15-minute test charge, it is time to replace the battery. Available through M.T.H. Parts. Lift Out Battery Figure 8. Battery Location. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Troubleshooting Proto-Sound® Problems Although Proto-Sound 2.0 has been designed and engineered for ease of use, you may have some questions during initial operation. The following table should answer most questions. If your problem cannot be resolved with this table, contact M.T.H. for assistance (telephone: 410-381-2580; fax: 410-423- 0009;...
Page 16
Because there are a limited number of sound clips available in each FYS/PSA sequence, it is probable that some of these sound clips will be repeated from time to time. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Page 17
FYS/PSA will advance to the next not come out of FYS/PSA after step in the FYS/PSA cycle. Wait fourth press of the direction at least 30 seconds in each button. FYS/PSA sound clip before pressing the direction button. Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
9-19v 110-Watt Standard Lionel SW Unknown 130-Watt Standard Lionel TW 8-18v 175-Watt Standard Lionel ZW A,B,C or D 8-20v 275-Watt Standard Lionel Post-War A,B,C or D Common 0-20v 135/190 Watt Electronic Celebration Series ZW Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Direction Control Set Up-User can set initial individual start-up direction (start in forward or reverse) for double- heading operations •Locomotive Consist Set-up-User can determine locomotive values for consist make-ups, allowing multiple locomotives belonging to a consist to operate together Railking FA-2 AA Diesel Engine Proto-Sound®2.0...
Service & Warranty Information How to Get Service Under the Terms of the Limited One-Year Warranty When you suspect an item is defective, please check the operator's manual for standard operation and trouble-shooting techniques that may correct the problem. Additional information may be found on the M.T.H.
Need help?
Do you have a question about the Railking FA-2 AA and is the answer not in the manual?
Questions and answers