Table of Contents
Advertisement
3.3. Battery loading
Battery type: R03/LR03/AAA x 2
2
3
1
~
Put batteries as shown in the figure above.
1
3
Press
to start clock setting.
4
Press
5
to Sunday).
* By pressing
changed from a 24-hour to a 12-hour clock.
Press
to continue.
6
Press
7
Press the buttons to change the clock by a minute.
Press down the buttons to change the clock by 10 minutes.
Press
8
Be close to the indoor unit. If you press the button from a
distance, settings may not be properly sent.
NOTES:
• Use specified type of batteries only.
• Do not mix different types or new and used batteries together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the
batteries, and press
En-5
8
4
(
)
to set day of the week (Monday
, the time indicator can be
(
)
to set the clock.
to complete the setting.
as shown in page 4.
4. BASIC OPERATIONS
„ 3 steps to start operation
1. Press
to start or stop the operation.
6
2. Press
to select the operation mode.
5
The operation mode changes as follows.
AUTO
COOL
7
3. Press
The temperature changes by 0.5 °C increments.
Temperature setting range
Auto/Cooling/Dry
Heating
NOTES:
• In the Cooling or Dry mode, set the temperature lower than the
current room temperature.
• In the Cooling mode, the indoor unit fan may stop from time to time
to perform Fan control for energy saving that enables power-saving
operation by stopping the rotation of the indoor unit fan when the
outdoor unit is stopped.
In initial setting, this function is activated.
To deactivate the function, consult the installer or authorized service
personnel.
• In the Heating mode,
- set the temperature higher than the current room temperature.
- at the beginning of the operation, the indoor unit fan rotates at very
low speed for 3-5 minutes.
- the Automatic defrosting operation overrides the Heating operation
when necessary.
• In the Fan mode, temperature control is not available.
„ Temperature unit switching
1. Press
until only the clock is displayed.
2. Press down
The current temperature unit will be displayed. (Factory setting: °C)
3. Press
4. Press
to finish the setting.
If you do not press the button for 30 seconds, the displayed
temperature unit will be set.
5. AIRFLOW SETTINGS
5.1. Fan speed setting
Press
to control the fan speed.
)
The fan speed changes as follows.
(Auto)
(High)
When
is selected, the fan speed depends on the operating
condition.
To increase the air cleaning effect, set the fan speed to High.
DRY
FAN
to set the desired temperature.
18.0 to 30.0 °C
16.0 to 30.0 °C
for more than 5 seconds.
to switch the temperature unit. (°C ⇔ °F)
(Med)
(Low)
HEAT
(Quiet)
Advertisement
Table of Contents
