Technische Daten; Installation - Panta Trio Solar Instructions For Use Manual

HINWEIS: Wenn ihr Licht sich nicht automatisch aktiviert ist die Leuchte
NICHT defekt! Um die entleerte Batterie wiederaufzuladen, stellen Sie die
Leuchte in eine sonnenbeleuchtete Umgebung, um diese gut aufzuladen.
Danach können Sie diese wie gewohnt einsetzen.
REINIGUNG
Für optimale Ladeerfolge das Solarpanel unbedingt regelmäßig mit
einem feuchten Tuch abwischen. Ein sauberes Solarpanel nimmt
nämlich mehr Sonnenenergie auf.

TECHNISCHE DATEN:

Material
Batterie Li-Ion
LED
IP-Klassifizierung
Maße
Gewicht
IMPORTANT NOTES/SAFETY NOTICES
• Read this instruction manual carefully before using
the lamp! Observe the safety instructions during
installation. Retain this instruction manual for future
reference. If the device is passed on to third parties,
these operating instructions must also be passed on.
• Cease use of the device if it is damaged in any way.
• Do not swallow any small parts. Keep small parts out
of the reach of children. This product is not suitable for
children. This product is not a toy! Keep the device out of
the reach of children.
• Never attempt to replace the LED. The LED light cannot
be replaced.
• This device is NOT a toy - keep out of the reach of
children.
• Make sure that the skin, eyes and mucous membranes
never come into contact with battery fluid or acid. In the
event of contact with battery fluid, immediately rinse
the affected areas with plenty of clean water and seek
medical advice.
• The product is not suitable for household room lighting.
M33362_PantaTrioSolar_Manual_A5_20230614_TC.indd 5 M33362_PantaTrioSolar_Manual_A5_20230614_TC.indd 5
PC+ABS
3.7V ⎓ 2.400mAh, 8,88Wh
74 Stk., 5W
IP 44
28,2 x 13 x 10,5cm
417g
EN
TIPS:
• Choose a location for the device that receives as much direct
sunshine as possible during the day. Avoid areas under trees or
bushes, as these will prevent the device from charging properly.
• Do not install the device in the vicinity of an existing outdoor light. The built-
in sensor will prevent the solar light from being switched on.
• If you use the light in autumn and winter, please note that the battery may
not be fully charged due to fewer daylight hours. This can affect the lighting
duration.
• Keep the light away from sources of heat (such as barbecues) and open
flames.
• The selected location, weather conditions and number of daylight
hours directly influence the actual lighting duration.
• NOTE: The light sensor only allows the light to be activated in the
dark. We recommend a test in a dark room or in a closet.

INSTALLATION

IMPORTANT: Remove all packaging material from the device
BEFORE installation.
Variant 1: Wall mounting (#2) - for an outside wall, fence post or railing
Place the wall mounting bar on the wall as shown in #2A and determine
the best position. Then use a pencil or nail to mark the drilling points on
the wall through the holes in the wall mounting bar. If necessary, use
a drill (not included) to drill holes in the desired position on the wall/
surface. Now insert three dowels into the holes on the wall and fasten
the wall mounting bar to the wall with the screws. Now you can hang the
device on the wall mounting bar as shown in #2B.
Variant 2: Ground installation (#3)
CAUTION: Before embedding the holder in the ground, make sure
that the ground is soft enough. Hard ground can damage or break
the ground stake.
Insert the ground spike into the hole on the rear of the solar panel (#3A)
and adjust the angle so that the lamp receives enough sunlight during
the day. Place the ground spike vertically into the ground (#3B).
USE
MODE 1: Security mode
The light automatically switches to this mode when it is dark. If there
is movement, the light switches on for 30 seconds with 100%
luminosity and then switches off automatically if no further movement
is detected within 30 seconds.
Activating security mode: If you want to use this mode, press the
function switch (d) on the back of the device once.
MODE 2: Homecoming mode
When there is movement, the light switches on for 30 seconds with
100% luminosity and then continues to illuminate for another
5 minutes with approx. 30% luminosity. It then switches itself off
again until further movement is detected.
5
14.06.23 09:23 14.06.23 09:23