Installing The Digitizer - Hitachi StarBoard Link EZ2 User Manual

StarBoard Link EZ2

2.3.3 Installing the Digitizer

・Installing with Magnets
Align the center of the digitizer with the center of the projection area, 5cm (2 inches) above the
projection area, and install so it is parallel with the edge of the projection area.
Digitizer
・Installing to walls where magnets cannot be used.
(1) Fix the wall mount bracket on the back of the digitizer, with 2 machine screws.
Machine screws
Wall mount bracket
Center
5 cm (2 inches)
Projection Area
After installing the digitizer, check to make
sure does not slide down due to its own
weight, and that it is securely installed.
2-7
Assembly and Setup
English