Mitsubishi Electric MSZ-AP71VG-E3 Service Manual page 58

Fixing the indoor coil thermistor
*There are 2 forms of parts for fixing the indoor coil thermistor.
Clip shape
Position and procedure for mounting the clip-shape part
1. Set the indoor coil
thermistor in the center of
the clip-shape part.
NOTE:
Take care to avoid loss and accidental falling of the clip-shape part inside the unit.
Mount the clip-shape part on the marked position.
Do not pull the lead wire when removing the indoor coil thermistor.
© Copyright 2017 MITSUBISHI ELECTRIC CORPORATION
Issued: Aug. 2021. No. OBH788 REVISED EDITION-E
Issued: Oct. 2020. No. OBH788 REVISED EDITION-D
Issued: Dec. 2019. No. OBH788 REVISED EDITION-C
Issued: Mar. 2019. No. OBH788 REVISED EDITION-B
Issued: May 2018. No. OBH788 REVISED EDITION-A
Published: Dec. 2017. No. OBH788
Made in Japan
Holder shape
HEAD OFFICE: TOKYO BUILDING, 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
2. Check the (marked)
mounting position.
Specifications are subject to change without notice.
58
When fixing the indoor coil thermistor
to the clip-shape/holder-shape part, the
lead wire should point down.
About the
same length
3. Mount the
clip-shape part.