Working Environment; Assembly; Operations Start Procedure - Kamikaze KV 295 User Manual

ELECTRIC PRUNING SHEARS

11. WORKING ENVIRONMENT

• Keep temperature of environment at 10°C ~ 22°C when charging battery,
0°C ~ +45°C when battery is working.
• Keep tool at temperature of 0°C ~ +60°C when working
• Do not use in explosive atmosphere or near flammable substances or gases.
• Do not use in case of rain or on wet branches

12. ASSEMBLY

Check that the pruning shears and batteries
are clean and dry, and then place the battery
in the battery compartment on the pruner.

13. OPERATIONS START PROCEDURE

Please wear suitable cloth and glove when operate this
tool. Always check tools before use, make sure on/off
switch and safe switch are all ok. The power should be
put off when you loosen the trigger. Stop using the tool in case
of switch failure. Always check rated voltage of battery match
pruning shear.
Switch off the machine, blade will stop in many second,
must sure blade stop fully before touch it, otherwise blade
will hurt your body.
• Press the power switch. After warning tone, please pull the trigger two
times without holding. Do not overload cutting, it will protect pruning
shear and battery not be damaged. Do not cutting over the dimension
specified in the technical information table.
• User just loose trigger when the blade has been jammed by branch, the
blade will resume maximum position.
www.gruposanz.es
81