Adjusting The Height-Of-Cut - Toro ProLine 30135 Operator's Manual

Operation

Adjusting the Height-of-Cut

The height-of-cut is adjustable from 2" to 5" (51 to
127 mm) in 1/2-inch (13 mm) increments by
relocating the clevis pins in different hole locations in
brackets at each corner of the cutting unit (Fig. 9).
Stop the engine before adjusting the height-of-cut.
Note: All four pins must be in the same hole
location for even cutting.
8
1
2
3
4
5
6
7
9
Figure 9
1. 2" (51 mm) Cut Height
2. 2-1/2" (64 mm) Cut Height
3. 3" (76 mm) Cut Height
4. 3-1/2" (89 mm) Cut Height
5. 4" (102 mm) Cut Height
8
6. 4-1/2" (114 mm) Cut
Height
7. 5" (127 mm) Cut Height
8. Clevis Pin
9. Hairpin Cotter