Mitsubishi Electric Mr.SLIM PKA-A-KA6 Operation Manual page 10

9. Operation Manual for IR wireless remote controller
9.2. Operation
9.2.1. Turning ON/OFF
2
COOL
5
6
1
2
<To Start Operation>
Press the ON/OFF button 1.
• The display area come on.
<To Stop Operation>
Press the ON/OFF button 1 again.
• The display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the
operation is progress, the air conditioner will not start for about 3 minutes.
This is to prevent the internal components from being damaged.
9.2.2. Operation mode select
Press the operation mode button 2 and select the operation mode
(COOL) Cooling mode
(DRY) Drying mode
(FAN) Fan mode
(HEAT) Heating mode
(AUTO) Automatic (cooling/heating) mode
9.2.3. Temperature setting
To decrease the room temperature:
button 3 to set the desired temperature.
Press
The selected temperature is displayed
To increase the room temperature:
button 3 to set the desired temperature.
Press
The selected temperature is displayed
• Available temperature ranges are as follows:
Cooling/Drying: 19 - 30 °C, 67 - 87 °F
Heating: 17 - 28 °C, 63 - 83 °F
Automatic: 19 - 28 °C, 67 - 83 °F
9.2.4. Fan speed setting
Press the Fan Speed button 5 as many times as necessary while the
system is running.
• Each press changes the force. The currently selected speed is
shown at 5.
• The change sequence, and the available settings, are as follows.
FAN SPEED
Speed 1 Speed 2
4-speed
+
Auto
Speed 1 Speed 2
3-speed
+
Auto
10
3
F
3
5
6
2
.
3
.
3
.
Display
Speed 3 Speed 4 Auto
Speed 3 Auto
9.2.5. Airflow direction setting
<To Change the Airflow's Up/Down Direction>
With the unit running, press the Airflow Up/Down button
• Each press changes the direction. The current direction is shown at
6
.
• The change sequence, and the available settings, are as follows.
Remote controller
Swing
Auto
Wired type
Swing
IR Wireless
remote controller
9.3 Timer
COOL
ON/OFF button
1
Press the or button (TIMER SET).
• Time can be set while the following symbol is blinking.
OFF timer: A is blinking.
ON timer: A is blinking.
2
Use the and buttons to set the desired time.
3
Cancelling the timer.
To cancel the OFF timer, press the
To cancel the ON timer, press the
• It is possible to combine both OFF and ON timers.
• Pressing the ON/OFF button of the remote controller during timer
mode to stop the unit will cancel the timers.
• If the current time has not been set, the timer operation cannot be
used.
6
as necessary.
Display
1 2 3 4 5
1 2 3 4
button.
button.