LG WT7155CW-DLE7150W Owner's Manual page 133

Problem
Washer will not Extremely low water pressure.
operate.
• Check another faucet in the house to make sure that household water pressure is
Washer is too cold.
• If the washer has been exposed to temperatures below freezing for an extended period of
Washer is not filling Filter is clogged.
properly.
• Make sure that inlet filters on the fill valves are not clogged. Refer to Cleaning the Water
Inlet hoses may be kinked.
• Check that inlet hoses are not kinked or clogged.
Energy efficiency
• This is a High-Efficiency (HE) washer. As a result, the water level settings for this washer
Insufficient water supply
• Make sure that both hot and cold water faucets are turned on all the way.
Washer lid is open.
• Close the lid and make sure that nothing is caught under the lid preventing it from closing
Water level is too low.
• The water will not normally cover the clothes. The fill level is optimized for the wash
Water in the washer Drain hose is kinked, pinched, or clogged.
does not drain or
• Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under
drains slowly.
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
• Move the end of the drain hose so that it is lower than 96 inches (2.4 m).
Bleach does not Bleach dispenser cover is not properly installed (on some models).
dispense.
• Make sure that the bleach cover is properly installed and snapped into place before the
Bleach dispenser is dirty or clogged.
• Lift out the bleach dispenser cover and clean out the reservoir. Lint and other foreign
Premature Bleach dispenser filled for future load.
dispensing of bleach
• You cannot store bleach in the dispenser for future use. The bleach will be dispensed every
Overfilling the bleach dispenser
• Overfilling the bleach dispenser will cause the bleach to dispense immediately, which will
adequate.
time, allow it to warm up before pressing the Power button. Otherwise, the display will not
come on.
Inlet Filters in MAINTENANCE.
may be different than for conventional washer.
completely.
motion to achieve the best wash performance.
the washer.
beginning of the cycle.
debris that are collected inside the dispenser may prevent proper dispensing of the
bleach.
load.
damage the laundry or the washer. Always measure bleach, but never fill above the max
line on the dispenser. A half cup of bleach is sufficient for most loads. Never use more
than 1 cup of bleach.
Possible Cause & Solution
TROUBLESHOOTING 41