Advertisement
5.3.4.
Rotate the release valve control knob slowly anticlockwise.
SAFETY WARNING! Always lower in a slow and controlled manner and ensure that there are no persons or obstacles beneath the
‰
vehicle, or in the path of descent.
5.3.5.
Withdraw the jack from underneath the vehicle and lock the handle in the upper locking position.
6. MAINTENANCE
IMPORTANT: Only fully qualified personnel should attempt maintenance or repair.
6.1.
MONTHLY MAINTENANCE
6.1.1.
Lubrication is critical to jacks, since they support heavy loads. To keep the jack well lubricated, carry out the following steps:
Lubricate the ram, the linkages, the saddle and pump mechanism with light oil.
Grease the lifting arm, wheel bearings and axles.
Keep all jack surfaces and warning labels clean.
Check and maintain the ram oil level (Section 6.3).
6.2.
THREE MONTHLY MAINTENANCE
6.2.1.
At three monthly intervals, check the ram for any signs of rust or corrosion. Clean the ram as required and wipe with an oiled cloth.
6.3.
CHECKING THE OIL LEVEL
6.3.1.
Fully retract the ram by turning the release valve control knob anticlockwise.
6.3.2.
With the jack in the level position, remove the top cover carefully.
6.3.3.
Remove the oil filler plug.
6.3.4.
The oil should be level with the bottom of the oil filler hole. If it is not, top up with clean hydraulic jack oil (Sealey Part No: HJO500MLS or
HJO5LS).
6.3.5.
Replace the oil filler plug and check the jack operation.
6.3.6.
Bleed air from the hydraulic unit as required (Section 4.4).
NOTE: Always store the jack in the fully lowered position. This will protect critical areas from excessive corrosion.
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THIS PRODUCT.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN JACKS TO US.
Please telephone us on 01284 757500 to obtain the address and phone number of your local agent. If jack is under guarantee you can
also contact your local stockist.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call
our technical team on technical@sealey.co.uk or 01284 757505.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
5001.V4
Issue1
22/07/20
Advertisement
