Toro TimeCutter HD MyRide 75212 Operator's Manual page 45

Checking the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
7.9 mm (5/16 inch) lower than the rear of the mower,
adjust the blade level.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Carefully rotate the blades so they are facing
front to rear (Figure
4. Measure from the tip of the front blade to the
flat surface and the tip of the rear blade to the
flat surface (Figure
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade tip,
continue to the Leveling the Mower Deck (page
45) procedure.
Figure 63
1. Blades front to rear
2. Outside cutting edges
63).
63).
3. Measure from the tip of the
blade to the flat surface
here.
Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to Adjusting the Anti-Scalp Rollers (page
2. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 26).
3. Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets
4. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (Figure
1. Wood block—6.6 cm
(2-5/8 inches) thick
2. Wood block—7.3 cm
(2-7/8 inches) thick
g229304
5. Loosen the adjustment bolts on all 4 corners so
that the deck is sitting securely on all 4 blocks
(Figure 65).
45
Adjusting the Height of Cut
(Figure 64).
64).
Figure 64
3. Front edge
27).
g024428