Table of Contents
Advertisement
Quick Links
ELECTRIC FIREPLACE STOVE HEATER
Model Numbers: GL4201, GL4202, GL4203, GL4204
(WS-D-01, WS-D-01-1, WS-D-01-2, WS-D-01-3)
Read and understand this entire owner's manual, including all safety
information, before plugging in or using this product. Failure to do so could
WARNING
result in fire, electric shock, or serious personal injury.
Keep this owner's manual for future reference. If you sell or give this
CAUTION
product away, make sure this manual accompanies this product.
IMPORTANT SAFETY INFORMATION!
OWNERS MANUAL
AC 110-120V 60Hz 1500W
Website: GibsonLiving.com
Email: sales@gibsonliving.com
Advertisement
Table of Contents
Related Manuals for Eden Branch Products GL4201
Summary of Contents for Eden Branch Products GL4201
- Page 1 ELECTRIC FIREPLACE STOVE HEATER OWNERS MANUAL Model Numbers: GL4201, GL4202, GL4203, GL4204 (WS-D-01, WS-D-01-1, WS-D-01-2, WS-D-01-3) AC 110-120V 60Hz 1500W Read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could WARNING result in fire, electric shock, or serious personal injury.
- Page 2 WARNING ALWAYS keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the bottom, sides, and rear of this heater. ALWAYS attach the feet before using! NEVER plug in or operate this unit if the feet are not securely attached! ...
- Page 3 WARNING Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside! ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.
- Page 4 PREPARATION Remove all parts and hardware from the carton and place them on a clean, soft, and dry surface. Make sure all parts are dry, and the power cord and plug are not damaged. See IMPORTANT SAFETY INFORMATION on pages 2 and 3. ...
- Page 5 1) Carefully turn the STOVE (A) upside down and lay it on a clean soft surface. 2) Thread three SCREWS (C) through the holes in the leg, and into the stove frame. Partially tighten with a Phillips screwdriver. 3) Repeat Steps 2 and 3 for the other three legs. 4) Check the alignment and tighten all 12 screws securely with the screwdriver.
- Page 6 1. Press to turn on flame effect and 1. Flame effect and power light on enable heater. switch turn on. Heater switches will not work unless The heater is now enabled. this switch is turned on. ON/OFF 2. Power lights, heaters, and 2.
- Page 7 Plastic: Wipe with a slightly damp cloth and a mild solution of dish soap and warm water. NEVER use abrasive cleansers or any cleaner that could scratch the surface. Vents: Use a vacuum or duster to remove dust and dirt from the heater and vent areas. ...
Need help?
Do you have a question about the GL4201 and is the answer not in the manual?
Questions and answers