How To Use; Engine Zone/Speed Control; To Adjust Cutting Height; To Convert Mower/Rear Bagging/Side Discharging - Craftsman 21" MULTI-CUT 917.388732 Owner's Manual

The operation ofanylawn
mower canresult in
foreign o bjects thrown i nto
theeyes, which can result
insevere e ye damage.
Always wear s afety g lasses oreye
shields while operating your l awn mower
orperfo_ing
B ey adjustments or repairs.
We recommend a wide vision safety
mask over spectacles or standard safety
glasses.
HOWTO USEYOUR LAWN MOWER
ENGINE SPEED CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
• I, C AUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the dsk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
rums when the engine Is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower
wheels for high cut, adjust cutting height
to suityour requirements. Medium
position is best for most lawns.
To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is propedy positioned
when plate tab inserts into hole in lever.
Also, 9-pesition adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
LowerWheels_r HighCut P._ Tab_
RaiseWheels for LowCut Lever
TO CONVERT MOWER
Your lawn mower was shipped ready to
be used as a mulcher. To convert to
bagging or discharging:
REAR BAGGING
• Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
• To convert to mulching or discharging
operation, remove grass catcher and
close rear door.
Pivot pins Rear Gras
door oatche
Catcher frame hook
SIDE DISCHARGING
• Rear door must be closed.
• Open mulcher door and install dis-
charge deflector under guard as shown
• Mower is now ready for discharging
operation.
• To convert to mulching or bagging
operation, discharge deflector must be
removed and melcher door must be
closed.
SIMPLE STEPS TO REMEMBERWHEN
CONVERTING YOUR LAWN MOWER
FORMULCHING-
1. Rear door closed.
2. Mulcher door closed.
FOR REAR BAGGING -
1. Grass catcher installed.
2. Mutcher door closed.
FOR SIDE DISCHARGING -
1. Rear door closed.
2. Side discharge deflector installed.
_,CAUTION: Do not run your lawn
mower without rear door closed or
approved grass catcher in place.
Never attempt to operate the lawn mower
with the rear door removed or prepped
open.
7