Table of Contents
Advertisement
Front Panel
28
29
PHANTOM POWER
28
This switch when depressed, applies +15 VDC to all input XLR connectors to power microphones that
require phantom power.
Caution: When phantom power is switched on‚ make sure that any channel you are plugging a micro-
phone into is turned down and the Master Main and Monitor controls are set to minimum. Otherwise‚
there will be a loud pop in the system. For best results, first plug in all microphones into their respective
channels before phantom power is switched on. This reduces noise through the system and reduces the
chance of damage to the microphones. If phantom power is used‚ do not connect unbalanced‚ dynamic
microphones or other devices to the XLR inputs that cannot handle this voltage. (Some wireless receiv-
ers may be damaged. Consult their manuals.) The line input jacks are not connected to the phantom
supply and are safe for all inputs (balanced or unbalanced). An unbalanced to balanced impedance
converter such as the Peavey 5116 or a Peavey 1:1 Interface Adapter may also be used to isolate a micro-
phone from phantom voltage.
29
Bluetooth® Activation Button
Press and hold this button until the LED blinks 3 times, indicating the Bluetooth has been powered on or
off, then release. Once turned on, the Bluetooth will automatically enter pairing mode. You can pair any
Bluetooth-enabled device with the mixer using the PIN 7878. To clear the paired device memory, make
sure the Bluetooth is turned off and press and hold the button for at least 10 seconds. The LED will
initially blink 3 times but then should remain off. Once you have released the button after 10 seconds,
you can proceed by powering it on as normal, and the memory will be cleared.
BLUETOOTH® LED
30
Indicates that the XR 1000L is receiving signal from a Bluetooth® device. LED blinks while finding a
signal and is solid once paired with the Bluetooth® device.
RECORD LEVEL
31
This knob adjusts the main signal level sent to the RCA record outs.
RCA RECORD OUT
32
This pair of RCA jacks provides a signal to the recording inputs of a CD recorder, stereo tape deck, or other
recording device.
NOTE: Do not connect a single device to the Media In (12a/12b) and Record Out (33). This improper
setup forms a loop, which can cause severe feedback. Use separate devices for recording and playback.
FOOTSWITCH
33
This 1/4" TRS (tip ring sleeve) jack accepts a momentary 1/4" TRS dual button footswitch (Peavey part num-
ber 03014070) designed to defeat the effects on all channels and activate the MASTER MUTE switch (21).
This function is extremely useful for playing program music during breaks.
MONITOR OUT
34
This 1/4" jack provides a signal from the monitor mix (4) for an external power amplifier. An external
power amplifier, such as our IPR® series of amplifiers, can then drive additional monitor speakers.
MAIN OUT
35
This 1/4" jack provides a signal from the main mix (after the graphic EQ) for an external power amplifier.
An external power amp, such as our IPR series of amplifiers, can then drive additional speakers.
31
30
32
33
19
34
35
Advertisement
Table of Contents
