Frequency Response; Power Requirements - Peavey PV14 Operating Manual

PV 10, PV 14, & PV
™ ™

Frequency Response

Mic Input to Left/Right Output
Total Harmonic Distortion
<0.02% 20 Hz to 20 kHz Mic to Left/Right Output
<0.005% Typical
<0.0007% Mic Pre-amp Distortion
Hum and Noise
Output Residual Noise S/N Ratio
Master Left/Right -97 dBu
-90 dBu
-83 dBu
Monitor Send -95 dBu
-80 dBu
Effects Sends -100 dBu
-80 dBu
(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
-129 dBu (input terminated with 150 ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) >90 dB
Left to Right Outputs (1 kHz) >75 dB
Common Mode Rejection Ratio (Mic Input)
50 dB minimum (20 Hz to 20 kHz)
70 dB typical @ 1 kHz
Meters
8 segment, peak reading (0 db = +4 dBu)
Dimensions
PV10: 12.125" wide x 14.75" deep x 3.5" high
(30.80cm x 37.47cm x 8.89cm)
PV14: 16.125" wide x 14.75" deep x 3.5" high
(40.96cm x 37.47cm x 8.89cm)
Installation Note:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
PV10: 9.3 lbs. (4.22 kg)
PV14: 12.1 lbs (5.49kg)
PV20: 16.3 lbs. (7.39kg)
20 Specifications
™
101 dB
94 dB
87 dB
99 dB
84 dB
104 dB
84 dB
14 Hz to 25 kHz +0 dB/-1 dB
(10 Hz to 80 kHz BW)
(22 Hz to 22 kHz BW)
Test Conditions
(Ref: +4dBu)
Master Fader Down, Channel Levels Down
Master Fader Nominal, Channel Levels Down
Master Fade Nominal, Channel Faders Nominal,
Panned Odd Channels (left), Even Channels (right)
All controls off
All channel sends nominal, masters nominal
All controls off
All channel sends nominal, masters nominal
Mute Button Attenuation (1 kHz) >90 dB
Channel Fader Kill (1 kHz) >85 dB
Signal/Overload Indicators
Red LED lights 3 dB below clipping
PV20: 22.125" wide x 15.75" deep 3.5" high
(56.2cm x 40.0cm x 8.9xm)

Power Requirements

PV10: 100-240 VAC 50/60 Hz 13 Watts
PV14: 100-240 VAC 50/60 Hz 17 Watts
PV20: 100-240 VAC 50/60 Hz 27 Watts
1